Back cover or battery cover adhesive by Samsung Galaxy A17 5G SM-A176F GH81-27932A Service Pack

Back cover or battery cover adhesive for Samsung Galaxy A17 5G SM-A176F GH81-27932A Service Pack

Back cover or battery cover adhesive for Samsung Galaxy A17 5G SM-A176F in Service Pack quality, designed to recover the correct fixing of the rear cover after a repair or component replacement. This spare part allows the rear cover of the device to be resealed when the original adhesive has lost adhesion, has deformed during disassembly or needs to be replaced to guarantee a clean and stable closure.

The GH81-27932A reference is intended for professional assembly of the Samsung Galaxy A17 5G, maintaining the correct fit between the battery cover and the chassis of the terminal. It is an especially useful part in screen, battery, charging connector, camera, board repairs or any intervention that requires removing the rear cover of the device.

Key features

Back cover adhesive for Samsung Galaxy A17 5G.

Compatible with technical model SM-A176F.

Samsung reference GH81-27932A.

Service Pack spare part for professional repair.

Allows recovery of the sealing and fixing of the battery cover.

Designed to maintain the correct fit between rear cover and chassis.

Service Pack quality guarantees a precise format, good adaptation to the contour of the terminal and reliable installation when applied to clean and properly prepared surfaces. This adhesive helps avoid lifting, looseness or irregular closures after a repair, improving the final finish of the device and the stability of the rear cover.

Its use is recommended whenever the Samsung Galaxy A17 5G SM-A176F is opened, as the previous adhesive usually loses fixing capacity when removed. It is aimed at technicians and workshops that need an identified spare part, with a specific reference and prepared to close the terminal safely after the intervention. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before continuing with any internal repair.

Completely remove the remains of the previous adhesive.

Clean the contact surface before applying the new adhesive.

Align the adhesive respecting the contour of the rear cover.

Avoid touching the adhesive area with your fingers during installation.

Apply even pressure on the cover for 20–30 minutes after closing.

Check that there are no raised areas before delivering the terminal.

Technical table