Board Charging Connector by Realme GT Master 5G RMX3363 Service Pack

Charging connector module for Realme GT Master 5G (RMX3363) Service Pack

This Service Pack charging connector module for Realme GT Master 5G RMX3363 is designed to restore charging capability, data transmission and USB detection with maximum reliability. It is the replacement used in professional technical environments to ensure direct compatibility with the motherboard, maintaining the mechanical and electrical tolerances required for precise assembly. The flex integrates the USB-C port, communication and ground lines, allowing the technician to resolve common faults such as intermittent charging, no charging, disconnections when moving the cable or incompatibilities with fast chargers. Its Service Pack format ensures installation without additional adjustments, with firm connectors and a design fully aligned with the RMX3363 hardware. Ideal for repairs where long-term stability and minimal recurrence are essential.

Key features
• Service Pack format with direct compatibility for Realme GT Master 5G RMX3363
• Complete flex with USB-C port and data lines
• Electrical stability and uniform contact on the board
• Fast assembly and precise tolerances
• Robust connectors to minimize post-repair failures

Advantages and quality
The Service Pack quality offers a superior assembly level and reliability equivalent to the technical standard used in official repairs. The flex design ensures firm contact, reduced interference and stable electrical continuity, restoring fast charging and stable data transfer. Precision in the fit facilitates mounting, avoids undue pressure on the motherboard and significantly reduces the possibility of recurrent failures. It is a replacement designed for workshops seeking durability and consistent performance after service.

Installation tips

1. Always disconnect the battery before handling the flex.

2. Check the USB-C cable and charger status before closing the device.

3. Insert the connector into the board without forcing and verify alignment.

4. Replace adhesives and clean any dirt or moisture.

5. Perform a full charging and data transfer test before final closure.

Technical table