Blackview P10000 Pro spare parts

Blackview P10000 Pro Technical Characteristics

The Blackview P10000 Pro is a robust smartphone known for its impressive battery power and durable structure. Here are some essential technical specs:

• Battery: A whopping 11000mAh battery.
• Display: A 5.99" Full HD screen with a 1080x2160 resolution.
• Camera: Dual rear camera (16MP+0.3MP) and dual front camera (13MP+0.3MP).
• Processor: A powerful MediaTek Helio P23 processor.
• RAM: A substantial 4GB.
• Storage: 64GB internal storage, expandable with a microSD card.

Instructions for Replacing Blackview P10000 Pro Repuestos

These instructions provide step-by-step guide on how to disassemble the phone, replace the necessary components, and reassemble. Please take utmost care while following these instructions to avoid any injury or further damage to device.

Tools Needed:

• Screwdriver
• Spudger
• Tweezers
• Pry Open Tool

Disassembly

Begin by turning off your phone to prevent any electrical damage during the disassembly.

• Remove the screws located at the bottom of the phone, then use the pry open tool to separate the back cover from the main body of the phone.
• Once inside, locate and disconnect the battery connector from mainboard. Use spudger for this task.
• Remove the screws holding down the motherboard and gently lift it out from chassis. Make sure to disconnect all flex connectors attached to the motherboard.

Replacing Components

Depending on the components 'repuestos' you have, this is how you replace them.

• If it's the battery, just place the new battery in place and reconnect battery connector to mainboard.
• If it's the screen, disconnect the old screen assembly, then replace it with the new one. Connect the new screen assembly to the mainboard.
• If it's the rear/front camera, locate the camera on the motherboard, disconnect it and replace with the new one by connecting it to the motherboard.

Reassembly

After replacing the components 'repuestos', it's time to put your phone back together.

• Return the mainboard to its original position within the chassis and secure it in place with screws. Don't forget to connect all flex connectors back to the motherboard.
• Connect the battery connector back to mainboard and secure it in position.
• Finally, snap back the cover onto the phone's body and secure it with screws at the bottom.

Turn on your phone to check if everything is working correctly. Remember to be careful while dealing with electronics and small components.