Cubot King Kong 7 spare parts

Technical Characteristics of Cubot King Kong 7

The Cubot King Kong 7 is a robust smartphone designed for durability and excellent performance. Here are the main technical characteristics:

• Screen: 6.36 inch, Full HD+ 1080 x 2300 pixels, IPS capacitive multi-touch screen
• Processor: Helio P60 Octa-core 2.0GHz
• RAM: 8GB
• Storage: 128GB, expandable up to 256GB with a microSD card
• Operating System: Android 11
• Battery: 6000mAh, non-removable
• Camera: Dual rear camera (48MP main + 5MP depth), 24MP front
• Network: Supports 4G, 3G, 2G
• Connectivity: WIFI 802.11a/b/g/n, Bluetooth 5.0, GPS, USB Type-C
• Sensors: Accelerometer, Gyro, Geomagnetic, Fingerprint sensor (side-mounted)

Instructions on How to Replace Cubot King Kong 7 Components

Prepare before you start

Make sure to turn off the phone, remove the SIM card, SD card, and battery if it’s removable. You'll also need a set of phone repair tools including a screwdriver, tweezers, pry tools, and a suction cup.

Step 1: Remove the back cover

Undo the screws at the bottom of the phone. Use a suction cup and a pry tool to separate the back cover from the phone body. Be careful not to damage the fingerprint cable attached to the cover.

Step 2: Disconnect the battery

Find the battery connection on the mainboard and gently disconnect it. It's a good precaution to avoid short circuits during the repair process.

Step 3: Replace the necessary component

A. If replacing the screen, disconnect the display cable and remove the screen assembly from the phone body. Attach the new display and connect the cable.

B. If replacing the camera, remove the protective cover, disconnect the camera cable then replace it with the new one. Make sure to screw back the protective cover.

C. If replacing the speaker, remove the protective cover, and disconnect the speaker cable. Replace with the new speaker, then reattach the protective cover.

Step 4: Reassemble the phone

Reconnect the battery and attach the back cover to the phone body. Screw back the screws that were undone at the start. Turn on the phone to check if the replaced component is working.

Please note that this is a general guide. Some steps might be slightly different depending on the exact model of the Cubot King Kong 7.