Cubot King Kong Mini 2 Pro spare parts

Technical Specifications of Cubot King Kong Mini 2 Pro Spare Parts

The Cubot King Kong Mini 2 Pro is a standout smartphone due its robust and durable design. Below are the specifications for the major spare parts and components:

• Screen: This device utilizes a 4.0-inch QHD+ display with a resolution of 1080 x 2300 pixels.
• Battery: The phone is powered by a 3000 mAh non-removable lithium-ion battery.
• Camera: The device touts a 13 MP rear camera and a 8 MP front camera.
• Processor: A powerful Quad-Core processor under the hood ensures smooth performance.

Instructions on How to Replace Cubot King Kong Mini 2 Pro Spare Parts

Precautions:

Please note that the following instructions are for those with experience in smartphone repair. If you do not have the necessary experience or tools, please consult with a professional.

Screen Replacement:

• Power off the device and remove the SIM card tray.
• Use a heat gun to warm up the adhesive surrounding the screen. Be careful not to overheat the device.
• Apply a suction cup to the front of the screen and gently pull up. Then, use a plastic pick to break the seal of the adhesive.
• Lift the screen, unclip the connecting cables, remove the old screen.
• Attach the new screen, ensuring the connecting cables are properly clipped in, then reapply adhesive and carefully press down to ensure a good seal.

Battery Replacement:

• Following the screen removal instructions, carefully remove the screen.
• Unscrew the screws holding the battery connector in place, then unclip the connector.
• Use a plastic pick to gently pry out the battery. Do not use metal tools as they could damage the battery and cause it to leak or explode.
• Place the new battery inside the compartment, reclip the connector and screw it back in place.
• Reattach the screen following the previous instructions.

Camera Replacement:

• After screen removal, locate the camera module.
• Unclip the connector cable for the camera, then remove any screws holding it in place.
• Remove the old camera module and replace it with the new one. Make sure to reclip the connector cable and screw the module into place.
• Reattach the screen following the screen reattachment instructions given earlier.