Cubot P30 spare parts

    There are 31 products.

    Cubot P30 Repuestos Technical Specifications

    The Cubot P30 repuestos are parts designed to fit specifically on the Cubot P30 device. The smartphone is known for its remarkable specifications as listed below:

    • Display: 6.3" FHD+ waterdrop screen with a screen resolution of 1080 x 2340 pixels.
    • RAM/ROM: 4GB/64GB, expandable up to 128GB via TF card....

    Cubot P30 Repuestos Technical Specifications

    The Cubot P30 repuestos are parts designed to fit specifically on the Cubot P30 device. The smartphone is known for its remarkable specifications as listed below:

    • Display: 6.3" FHD+ waterdrop screen with a screen resolution of 1080 x 2340 pixels.
    • RAM/ROM: 4GB/64GB, expandable up to 128GB via TF card.
    • Processor: Helio P23, Octa-Core 2.0GHz.
    • Battery: 4000mAh, Non-removable.
    • Operating System: Android 9.0 Pie.
    • Camera: Triple Rear cameras (20MP+12MP+8MP) and a 13MP front camera.

    Instructions on How to Replace Cubot P30 Repuestos

    Please follow these step-by-step instructions to safely replace Cubot P30 parts:

    Preparation

    • Ensure the smartphone is powered off to avoid any short circuits during the procedure.
    • Organize your workspace. Have all the necessary repair tools (screwdrivers, pryer, suction cups, tweezers, etc.) at hand.
    • Protect the front and back covers of the smartphone with a heat-insulating tape or similar, to prevent scratches.

    Opening the Device

    • Use a heat gun to warm the edges of the smartphone to about 60°C. This will soften the adhesive securing the back cover.
    • Place a suction cup on the back of the device and gently lift it. Insert a plastic pryer in the small gap and glide it around the edges to fully remove the back cover.

    Replacing Components

    • To replace the battery: Find and remove any screws holding the battery. Gently lift it up using a pryer, disconnect the connector and replace it with the new one.
    • To replace the screen: Disconnect the connectors and remove the screws holding the screen assembly. Take out the old screen and replace it with the new one.
    • To replace cameras: Unclip the connectors attached to the cameras, remove any screws, and replace them.

    Reassembly

    • Ensure all replaced components are correctly fitted and secured.
    • Reconnect any disconnectors.
    • Gently snap-back the rear case onto the phone's body.

    Remember to power-ON the device to verify the functionality of the replaced parts.

    Less
    More
    Showing 1 - 30 of 31 items