Cubot X20 Pro spare parts

Cubot X20 Pro Repuestos Technical Specifications

The Cubot X20 Pro is a high-performance smartphone with impressive specs. Below, you'll find key components making up the Cubot X20 Pro Repuestos:

• Screen: 6.3-inch IPS capacitive touchscreen, 1080 x 2340 pixels
• Processor: MediaTek Helio P60 (MT6771), Octa-Core (4 x 2.0GHz Cortex A73, 4 x 2.0GHz Cortex A53)
• Memory: 6GB RAM with 128GB built-in storage
• Camera: Triple rear camera (12MP Main + 20MP Depth + 8MP Wide) & 13MP front camera
• Battery: Non-removable Li-Po 4000 mAh battery

Instructions on Replacing Cubot X20 Pro Repuestos

Before proceeding with these instructions, ensure you have the necessary tools like a plastic opening tool, small Phillips screwdriver, tweezers, and a spudger. In addition, always remember to switch off your Cubot X20 Pro before commencing any repairs.

Step 1: Remove the Back Cover

Using the plastic opening tool, pry the back cover starting from the bottom edge moving around the sides. Lift up the back cover once all clips are disengaged.

Step 2: Removing the Battery

Unscrew the small Phillips screws holding the battery connector. Remove the battery using a spudger to lift it up gently to prevent any damage.

Step 3: Removing the Motherboard

Take out all screws connecting the motherboard to the frame. Carefully lift it, disconnecting any visible connectors.

Step 4: Removing the Cameras

Use the tweezers to disconnect the connectors holding the cameras onto the motherboard. Lift up the cameras out of their slots.

Step 5: Replacing Needed Parts

Replace the necessary parts and follow these steps in reverse to reassemble the phone.

Note: Before reassembling, ensure all parts and connectors are clean and free from any dust.