Cubot X50 spare parts

Technical Characteristics of Cubot X50 Repuestos

The Cubot X50 Repuestos are components designed specifically for Cubot X50 smartphones. They enable you to maintain the functionality of your device.

• Display: 6.67 inch Full HD+ 1080x2400 IPS screen
• Processor: Helio P60 Octa-core processor
• Memory: 8GB RAM and 128GB storage
• Camera: Quad camera setup - 64MP main, 16MP ultra-wide, 5MP macro and 0.3MP depth sensor
• Battery: 4500mAh with fast charging support

Instructions to replace Cubot X50 Repuestos

Before proceeding, ensure you have all necessary tools and the specific required Repuestos. Unqualified personnel can cause further damage. Always remember to turn off the device before starting.

Step 1: Back Cover Removal

Loosen the two screws at the bottom of the Cubot X50. Insert a thin pryer into the small gap and slide it along the edge to remove the back cover. Be careful not to damage the side buttons or the camera lens.

Step 2: Battery Removal

Once the back cover is removed, you can see the battery connector. Unplug it and carefully remove the battery. Remember not to pry against the motherboard or you might damage internal components.

Step 3: Mainboard Removal

Before removing the mainboard, disconnect all the flex cables attached to it. Unscrew all the screws holding the mainboard and gently lift it out of the phone.

Step 4: Replacing Repuestos

Identify the part that needs replacement. Some Repuestos such as screen, camera, and speaker come attached to the mainboard. Replace the part and return the mainboard into the phone.

Step 5: Assembling the Phone

Start by reconnecting all the flex cables previously disconnected. Carefully place the battery back, ensuring proper alignment and connector plug-in. Lastly, secure the back cover by pressing the edges until it clicks into place. Turn on the phone to confirm the repair.

Note: This is a generic guide. Always check for specific repair manuals related to the repair or replacement you are doing.