Elephone S3 repuestos

Elephone S3 Repuestos - Technical Characteristics

The Elephone S3 is a sleek and modern smartphone. When it comes to replacing parts, the phone's design allows for the easy removal and insertion of components. We'll be examining some of the phone's critical technical aspects and how to replace them accordingly.

Main Components of Elephone S3

• Display: 5.2 inches with a Full HD, bezel-less design, 1080 x 1920 pixels resolution.

• Battery: Non-removable Li-Po 2100 mAh battery.

• Camera: 13MP Rear Camera and 5MP Front Camera.

• Processor: Powered by MediaTek MT6753.

• Memory: ROM 16 GB + RAM 3 GB.

• Operating System: Android 6.0 Marshmallow

Instructions for replacing Elephone S3 Repuestos

Tools Required

• Precision screwdriver set
• Plastic prying tools
• Tweezers
• Suction cup

Battery Replacement

As the battery is non-removable, it would require a basic understanding of smartphone disassembly.

• Power off the Elephone S3.
• Remove the SIM card tray.
• Using the plastic prying tool, carefully open the back cover along the edges of the phone.
• Find the battery connector and disconnect it.
• Remove the screws securing the battery.
• Use the plastic prying tool to lift and remove the battery.
• Place the new battery, screw it carefully, and finally, connect the battery connector.
• Assemble the phone by following the disassembly steps in reverse order.

Screen Replacement

Please note that the utmost care must be taken while replacing the screen, as any damage can affect the phone's functionality.

• Power off the Elephone S3 and remove the SIM card tray.
• Use the plastic prying tool to carefully remove the back cover.
• Disconnect the screen connector.
• Remove the screws holding the screen.
• Use the suction cup to lift and remove the screen carefully.
• Place the new screen, secure it by screwing it carefully and connect the screen connector.
• Assemble the phone by following the disassembly steps in reverse.

Make sure to test the new components thoroughly once the replacement is done before the final assembly.