Huawei Honor Magic 4 PRO 5G spare parts

Huawei Honor Magic 4 PRO 5G Repuestos Technical Specifics

The Huawei Honor Magic 4 PRO 5G presents an array of impressive technological specifications, each component named as "Repuesto" (Spare part). Here are few key components.

• Screen: Equipped with a 6.76 inch OLED display with 2772 x 1344 pixel resolution, 120Hz refresh rate, and HDR10+ support.
• CPU: Features a Snapdragon 888+ SoC with a 1x3.00 GHz Cortex-A78 & 3x2.42 GHz Cortex-A78 & 4x1.8 GHz Cortex-A55 processing structure.
• Battery: Comes with a 4600mAh battery, which supports 66W wired and 50W wireless fast charging.
• Cameras: Incorporates a triple camera system with a 50MP primary sensor, 64MP ultra-wide sensor, 64MP periscope telephoto sensor, and a 13MP under-display selfie camera.
• Motherboard: The miniboard used is a Huawei motherboard compatible with a Snapdragon 888+ SoC.

Replacing Huawei Honor Magic 4 PRO 5G Repuestos

Replacing components on a Huawei Honor Magic 4 PRO 5G can be a delicate task. So, proceed with caution. Make sure your phone is powered off and not connected to any power source before you begin.

Instructions

• Step 1: For any part replacement, you need to remove the rear cover first. Heat the edges of the device to soften the adhesive. Then use a suction cup and plastic opening tools to gently remove the back cover.
• Step 2: Once the back cover is off, using the appropriate screwdriver, carefully remove all screws on the protective plate to expose the motherboard and battery.
• Step 3: Depending on the repuesto to be replaced, proceed to disconnect the appropriate flex cables from the motherboard.
• Step 4: If you're replacing the screen, remove the faulty screen and replace it with the new one. Carefully connect the flex cable for the screen to the motherboard.
• Step 5: For camera or battery replacements, gently lift the old part and replace it with the new one. Connect the flex cables or contact points to the respective terminals on the motherboard.
• Step 6: Once the replacement is done, secure the protective plate back and screw it in carefully.
• Step 7: Finally, reattach the back cover and softly press along the edges until it clicks into place. It can be heated slightly to secure the adhesive.

Note: Always remember to wear antistatic wrist straps for safety and never force a connection if it doesn't fit.