Huawei Honor Magic 5 Lite 5G spare parts

    There are 39 products.

    Huawei Honor Magic 5 Lite 5G repuestos - Technical Characteristics

    The Huawei Honor Magic 5 Lite 5G is a high-performance smartphone with a range of key technical features that distinguish it in the smartphone market. Here are some essential characteristics of its components, commonly referred to as repuestos.

    • Display: 6.6 inch OLED panel with...

    Huawei Honor Magic 5 Lite 5G repuestos - Technical Characteristics

    The Huawei Honor Magic 5 Lite 5G is a high-performance smartphone with a range of key technical features that distinguish it in the smartphone market. Here are some essential characteristics of its components, commonly referred to as repuestos.

    • Display: 6.6 inch OLED panel with a resolution of 1080 x 2340 pixels.
    • Processor: Kirin 990 5G octa-core processor.
    • Storage: 6GB or 8GB RAM paired with 128GB or 256GB storage.
    • Battery: A non-removable Li-Po 4200 mAh battery.
    • Cameras: The device features a rear quad-camera setup with a 64MP wide lens, a 16MP ultrawide lens, a 2MP macro lens, and a 2MP depth sensor. The front camera is a 32MP lens.

    Instructions for replacing Huawei Honor Magic 5 Lite 5G repuestos

    Before starting, make sure you have the appropriate tools, such as a Philips #000 screwdriver, a plastic opening tool, tweezers, and a spudger. Always make sure your device is powered off before you begin.

    Step 1: Removing the Back Cover

    Starting from a corner of the phone, insert the plastic opening tool between the back cover and the frame. Carefully slide the tool around the entire phone to loosen the adhesive holding the back cover in place. Once the adhesive is loosened, you should be able to remove the back cover.

    Step 2: Unscrew the shield cover

    Once the back cover is removed, you will see a plastic shield cover held in place by several screws. Use your Philips #000 screwdriver to remove these.

    Step 3: Disconnect the battery

    With the shield cover removed, locate the battery connector. Use the spudger to carefully disconnect the battery connector from the motherboard.

    Step 4: Replace the Component

    The specific steps here will depend on the component you are replacing. In general, locate the faulty component and carefully remove it from the motherboard. Then, place the new component in the same spot and secure it.

    Step 5: Reassemble the Phone

    Once the component is replaced, reconnect the battery and put the shield cover back on, securing it with the screws. Finally, place the back cover on and press firmly around the entire phone to secure the adhesive.

    Remember, components can be delicate - always handle with care and avoid forceful actions.

    Less
    More
    Showing 1 - 30 of 39 items