Huawei Nova 3 spare parts

Huawei Nova 3 repuestos: Technical characteristics

The Huawei Nova 3 comes with a wide range of components, known as repuestos. These include:

• Screen: The Nova 3 features a large 6.3" IPS LCD with a resolution of 1080 x 2340 pixels.
• Camera: It houses a Dual camera of 16 MP + 24 MP on the rear and a 24 MP + 2 MP dual front-facing camera.
• Battery: The device is powered by a 3750 mAh non-removable lithium-polymer battery.
• Processor: The chipset of Huawei Nova 3 is HiSilicon Kirin 970, with an octa-core processor.
• RAM: The device also has 4GB/6GB RAM and 128GB storage.
• Motherboard: It supports dual SIMs and integrates the processors, memory, and storage.

Instructions for replacing Huawei Nova 3 repuestos

1. Tools needed

The following toolkit will be required for the replacement:

• Small Phillips screwdriver
• Small flathead screwdriver
• Pry tool or plastic opening tool
• Eject Pin
• Heating pad or hairdryer to heat adhesive strips

2. Power off the device

Before beginning any repair works, ensure that the device is turned off. This is to protect from unwanted shorts and the user from any harm.

3. Removing the back cover

Start by removing the back cover of the phone. Use the heating pad or hairdryer around the edges of the back cover, this will loosen the glue. Then use the pry tool to carefully lift it up.

4. Unscrewing the shield cover

With the small Phillips screwdriver, remove the screws holding the shield cover over the battery and other components. Lift the shield cover using the pry tool.

5. Disconnecting the battery

Disconnect the battery connector from the motherboard. This will ensure that no electricity is flowing through the device and can prevent damage during the repair.

6. Replacing the necessary part

Locate the part that needs to be replaced. Unscrew and carefully remove it. Replace it with the new part by gently inserting it into place and screwing it back in.

7. Reassembling the device

After the part has been replaced, reconnect the battery and put the shield cover back. Screw it back in. Then, reattach the back cover, ensuring that it strongly sticks.

8. Power on the device

Turn on your device to check if the replacement part works correctly. If not, it is recommended to take the device to a professional.