iPhone 4S spare parts

Technical Characteristics of Repuestos iPhone 4S

The Repuestos iPhone 4S provides several components required for maintaining and repairing an iPhone 4S device. Below, you'll find the key specifications for these components.

• Display: The screen is a 3.5-inch Retina display with a resolution of 640x960 pixels.
• Battery: It is a lithium-ion battery with a capacity of 1430 mAh.
• Rear camera: The rear camera module is an 8-megapixel camera capable of recording HD videos.
• Front camera: The front camera module consists of a VGA-resolution camera for video calls.
• Home button: This is a physical button located at the bottom of the device.

Instructions for Replacing Repuestos iPhone 4S

Tools Needed

You’ll need a Phillips #000 screwdriver, a Pentagonal P2 screwdriver, a plastic opening tool, a suction cup, and a spudger.

Step 1: Remove the Rear Cover

Unscrew the two pentagalobe screws at the bottom of the iPhone. Put the suction cup on the back of the iPhone, then pull the rear panel away from the back of the iPhone.

Step 2: Disconnect the Battery

Use your Phillips #000 screwdriver to remove the screw securing the battery connector. Use a plastic opening tool to gently pry the battery connector up from the socket on the logic board.

Step 3: Removing the Display

Unscrew the four corner screws and the six side screws. Be sure to keep track of where each screw came from. Lift the front panel away from the body of the phone using a suction cup.

Step 4: Replacing the Component

Depending on the part you are replacing, the steps will vary. Always remember to handle parts carefully.

Step 5: Reassembly

Reconnect the display assembly to the logic board, and then reset the battery connector. Replace the rear cover and insert the two Pentagalobe screws back into place. Your iPhone 4S should now be fully assembled.