Spare Parts iPhone 7 plus

iPhone 7 Plus Replacement Parts and Procedure

Technical Specifications

When dealing with iPhone 7 Plus repair and replacement, you're likely to encounter the following components:

• Display: Retina HD display, 5.5-inch (diagonal) widescreen LCD
• Camera: 12-megapixel wide-angle and telephoto cameras
• Battery: Built-in rechargeable lithium-ion battery
• Home button: Capacitive, with integrated Touch ID sensor
• Speaker: Stereo speakers
• SIM tray: Nano-SIM

Replacement Procedure

The steps to replace a component in an iPhone 7 Plus are as follows:

1. Opening the iPhone

• Power off the device.
• Use a P2 Pentalobe screwdriver to remove the two bottom screws located next to the Lightning port.
• Use a suction cup and a plastic opening tool to pry the display assembly up from the case.

2. Removing the Display Assembly

• Remove the four tri-point screws securing the lower connector bracket, and the two Phillips screws securing the upper connector bracket.
• Disconnect the digitizer, LCD, sensor assembly, and home button connectors using a spudger tool.
• Lift the display assembly off the rest of the phone, bearing in mind that it is still connected by the camera and speaker connectors at the top.

3. Replacing the Component

Depending on the component you wish to replace, you may need to perform additional steps:

For Example, To Replace the Battery:

• Remove adhesive strips holding the battery in place, then lift the battery out with a plastic card.
• Install the new battery, reapply the adhesive strips, and replace the display assembly following the above steps in reverse order.

Please note: Always handle all parts with great care, especially the flex cables and connectors as they can be fragile. If you feel uncomfortable performing these steps, please seek professional assistance to prevent accidental damage.