iPhone 7 spare parts

Repuestos iPhone 7 Technical Specifications

The iPhone 7 uses several types of replacement components, known as 'Repuestos' in some regions. Below are some of the most common ones:

• Screen: An LED-backlit IPS LCD, capacitive touchscreen with 16M colors.
• Resolution: iPhone 7 features a resolution of 750 x 1334 pixels.
• Chipset: It runs on an Apple A10 Fusion chipset.
• Battery: A non-removable Li-Ion 1960 mAh battery (7.45 Wh).
• Front Camera: 7 MP, f/2.2, 32mm (standard).
• Rear Camera: 12 MP, f/1.8, 28mm (wide), 1/3", PDAF, OIS.
• RAM: iPhone 7 includes 2GB RAM.

Instructions for Replacing Repuestos iPhone 7

Tools Needed

Before starting any replacement, make sure you have the following tools:

• Pentalobe Screwdriver
• Philips #000 Screwdriver
• Spudger
• Tweezers
• Opening picks
• Suction Handle

Screen Replacement Procedure

Follow these steps to replace the iPhone 7's screen:

• Power off your iPhone 7 before beginning disassembly. Remove the two 3.4 mm pentalobe screws next to the lightning connector.
• Use a suction handle to gently pull up the screen, take caution not to pull up too much, it's still connected to the phone body.
• Use the spudger to disconnect the connectors holding the screen.
• After all the connectors are disconnected, you can fully remove the broken screen.
• Before installing the new screen, remove any remaining adhesive from the phone frame, then apply a new set of adhesive.
• Connect the new screen to the phone body using the previous connectors and gently test if the screen is working properly before finalizing the installation.
• Finally, reattach the two pentalobe screws next to the lightning connector.

Always remember to take your time and go slow. Some parts might need gentle persuasion to come apart.

Note: Always disconnect the battery before starting a repair and keep track of your screws, they are different sizes and using the wrong one can damage your device.