iPod Touch 3

iPod Touch 3 Technical Characteristics

The iPod Touch 3, released in September 2009, incorporates several significant technological advancements over its predecessor. Below are its key technical details:

• 32GB or 64GB capacity
• 3.5-inch (diagonal) widescreen Multi-Touch display
• 480-by-320-pixel resolution at 163 pixels per inch
• Supports AAC, MP3, WAV, AIFF audio formats
• Built-in Wi-Fi (802.11b/g)
• Built-in rechargeable lithium-ion battery
• Up to 30 hours of music playback

Replacing iPod Touch 3 Battery

Tools Required

• Small Phillips Screwdriver
• Precision Tweezers
• Safety Glasses
• Plastic Opening Tools (Spudgers)

Instructions for Replacement

Follow the step-by-step instructions mentioned below:

• Turn off the iPod Touch completely
• Loosen the two screws at the bottom of the device using the small Phillips screwdriver
• With the plastic spudgers, slowly pry open the screen from the body, starting from bottom and working your way around, until the screen is lifted
• Be careful not to pull the screen away too far, as it is attached to the motherboard with ribbon cables
• Detach these ribbon cables carefully using the tweezers. This will allow the screen to be completely removed
• The battery is located at the back of the device. It has a cable which connects it to the motherboard, which should be carefully detached
• Then, carefully remove the old battery and replace it with the new one. Make sure to place the new battery in the same position as the old one
• Reconnect battery connector to the motherboard
• Reattach the screen with the motherboard by reconnecting the ribbon cables
• Put the screen back into place and press it down. Ensure it is secure before tightening the two screws at the bottom

Now you have successfully replaced the iPod Touch 3 battery.