Lenovo K8 Plus spare parts

Technical Characteristics of Lenovo K8 Plus Replacement Parts

The Lenovo K8 Plus is a smartphone with a well-built design and robust hardware. Over a period of usage, you may require replacement parts (repuestos) for your device. This guide discusses the key repuestos for the Lenovo K8 Plus, including their technical characteristics:

• Front Glass, Touch Screen and LCD Display: This is a pre-assembled front glass, touch screen digitizer, and LCD display for the Lenovo K8 Plus. It features a 5.2-inch IPS capacitive touchscreen with 1080 x 1920 pixels resolution.
• Battery: The Lenovo K8 Plus uses a Lithium-ion battery with a capacity of 4000mAh.
• Back Cover and Housing: This is the external part of the smartphone that houses the battery and mother board. The back cover also includes the side buttons.

Instructions for replacing Lenovo K8 Plus repuestos

Please note that repairing a smartphone requires patience and finesse. Misusing the tools could cause further damage to the device. Follow these instructions for replacing Lenovo K8 Plus repuestos:

Tools Needed

• Tweezers
• Opening picks
• Screwdriver
• Spudger
• Hot air gun or a similar heat source

Replacing the Display

• Start by powering off your phone. Remove the SIM card tray and any external SD cards if any.
• Heat the edges of your display for about two minutes to loosen the adhesive. Use the opening picks to pry the screen loose but do it gently to avoid damage to the LCD.
• Once the screen is loose, remove the connector that attaches the display to the motherboard. Replace it with the new screen and retrace your steps backwards to reassemble your phone.

Replacing the Battery

• Start by removing the display as per the instructions above. The battery connector is located on the motherboard. Disconnect it carefully.
• Use the spudger to gently pry the battery loose from its adhesive.
• Place your new battery, reconnect the connector, and reassemble the other parts of your phone.

Replacing the Back Cover and Housing

• Remove the SIM card tray and any external cards. Then gently heat the back of your phone and use the opening picks to pry it open.
• Once open, remove the screws holding the housing in place.
• Replace it with the new housing and then follow your steps backwards to reassemble your phone.

Please ensure you stick to these instructions for safe and successful repair.