Motorola Moto E40 spare parts

Motorola Moto E40 Repuestos Technical Specifications

The Motorola Moto E40 is an elegant and durable smartphone which carries the following technical specifications:

• Screen: 6.5 inches, 720 x 1600 pixels, IPS LCD
• Processor: Unisoc T700
• RAM: 4 GB
• Storage: 64 GB, expandable via microSD card
• Battery: 5000 mAh, Li-Po
• Operating System: Android 11
• Camera: Triple-rear cameras (48 MP main, 2 MP macro, 2 MP depth) and a 8 MP front camera.

Instructions for Replacing Motorola Moto E40 Repuestos

Replacing the various parts (repuestos) of Motorola Moto E40 can be a sensitive process. However, with the right tools and attention to detail, it is manageable. Keep in mind, it is crucial to comply with safety standards while handling electronic devices for repairs, and to refrain from making attempts if unsure, to avoid causing further damage.

Tools Required

• Set of mini Phillips-head screwdrivers
• Suction cup
• Plastic opening tool
• Tweezers
• Spudger

Instructions to Replace Parts

Here is a step-by-step guide on how to replace the parts:

• Start by powering off the device to prevent any short circuit during the repair process.
• Remove the SIM card tray and memory card tray.
• Using a heating device, gently warm up the edges of the screen, which helps loosen the adhesive securing the screen to the frame.
• Gently place the suction cup on the screen and gently pull up to separate it from the body. Be very cautious not to pull very hard as the cables connecting the screen are still attached to the motherboard.
• Now that the screen is separated from the body, use the Phillips-head screwdriver to remove the screws securing the cover of the motherboard. Once done, carefully remove the cover to expose the motherboard.
• Use the tweezers to disconnect the flex cables connecting the screen to the motherboard. Now, you can remove the screen.
• To replace the battery, use the spudger tool to gently lift the battery off from the body.
• For parts on the motherboard like the camera, disconnect the flex cable connected and gently remove the part.
• Once your replacement is complete, simply reverse the steps to reassemble the phone. Make sure to connect all flex cables and re-screw all loose parts back to their original position.