Motorola Moto E6 Plus repuestos

    There are 15 products.

    Motorola Moto E6 Plus Specifications

    The Motorola Moto E6 Plus is an affordable smartphone that is versatile in everyday performance. Listed below are its important specs:

    • Display: 6.1 inches, IPS LCD (720 x 1560 pixels)
    • Processor: Mediatek MT6762 Helio P22 (12 nm)
    • RAM: 2/4 GB
    • Storage: 32/64 GB internal storage, expandable via microSD slot
    • Ba...

    Motorola Moto E6 Plus Specifications

    The Motorola Moto E6 Plus is an affordable smartphone that is versatile in everyday performance. Listed below are its important specs:

    • Display: 6.1 inches, IPS LCD (720 x 1560 pixels)
    • Processor: Mediatek MT6762 Helio P22 (12 nm)
    • RAM: 2/4 GB
    • Storage: 32/64 GB internal storage, expandable via microSD slot
    • Battery: Removable Li-Po 3000 mAh battery
    • Camera: Dual Rear camera - 13 MP, f/2.0, 1.12μm, PDAF 2 MP, depth sensor and Front Camera - 8 MP, f/2.0, 1.12μm

    Replacing Motorola Moto E6 Plus Repuestos...

    Tools Needed

    You will need the following tools:

    • Small Phillips Screwdriver
    • Spudger
    • Tweezers
    • Opening Tool/Pick

    Steps to Replace Parts

    Before you begin, remember to switch off the phone, remove your SIM and SD cards if any. Follow these steps:

    1. Remove the back cover: Begin by removing the back cover. Insert the opening tool into the small notch at the bottom of the phone, sliding it around the edges until the cover pops open.
    2. Remove the battery: Using the small notch on the bottom left side of the battery compartment, carefully lift and remove the battery from the phone.
    3. Remove 14 screws: Around the frame of the device, unscrew the 14 visible screws using the small Phillips screwdriver.
    4. Separate the mid-frame: Use the opening tool to separate the mid-frame from the screen assembly.
    5. Identify the part to be replaced: Locate the defective part for replacement. This will be located on the front assembly or the mid-frame, depending on what needs replacing.
    6. Remove the defective part: Using the appropriate tool, carefully lift and remove the defective part.
    7. Install the new part: Replace it with your new part, ensuring the correct orientation and fit.
    8. Reassemble the smartphone: Reassemble the device by following the disassembly steps in reverse order.

    Please remember to refer to a professional if you are unsure or uncomfortable performing the repair yourself. Mistakes could lead to further damage or voiding your warranty.

    Less
    More
    Showing 1 - 15 of 15 items