Motorola Moto E7 Plus spare parts

    There are 23 products.

    Technical Characteristics of Motorola Moto E7 Plus Repuestos

    The Motorola Moto E7 Plus replacement parts, or 'repuestos' as they are referred to in Spanish, feature several key components that are integral to the functioning of this smartphone.

    • Display: A 6.5-inch, 720 x 1600 pixels, HD+ Max Vision IPS LCD capacitive touchscreen display.
    • Batter...

    Technical Characteristics of Motorola Moto E7 Plus Repuestos

    The Motorola Moto E7 Plus replacement parts, or 'repuestos' as they are referred to in Spanish, feature several key components that are integral to the functioning of this smartphone.

    • Display: A 6.5-inch, 720 x 1600 pixels, HD+ Max Vision IPS LCD capacitive touchscreen display.
    • Battery: A non-removable Li-Po 5000 mAh battery.
    • Camera: A Dual 48 MP + 2 MP rear camera and 8 MP front camera.
    • Speakers: A bottom-ported loudspeaker.
    • Internal Parts: Power and volume key buttons, vibrator motor, various flex cables, and SIM card tray.

    Instructions on How to Replace Motorola Moto E7 Plus Repuestos

    Please note that mobile phone repair should be carried out with care following these general instructions. The steps might vary slightly depending on the specific repuesto being replaced.

    Tools needed:

    • Small Phillips Screwdriver
    • Plastic Opening Tools
    • Heat Gun/ blow dryer

    Disassembly:

    • Turn off your Motorola Moto E7 Plus and remove the SIM card tray.
    • Heat up the edges of the back cover with a heat gun or blow dryer on low heat to loosen the adhesive.
    • Carefully pry open the back cover using a plastic opening tool to prevent scratching.
    • Unscrew the 14 Phillips screws securing the plastic protective cover and remove it.

    Replacing the necessary part:

    At this point, depending on the part that needs to be replaced, the steps will vary. For example, to replace the battery:

    • Disconnect the battery flex connector from the motherboard.
    • Gently pry up the battery and remove it.
    • Place the new battery in the same space, and connect its flex connector to the motherboard.

    Reassembly:

    • Reattach the plastic protective cover and fasten it with the 14 Phillips screws.
    • Carefully attach the back cover, ensuring the adhesive sticks properly.
    • Insert the SIM card tray back into its slot.

    Please ensure to take necessary precautions and handle each component with care as they are delicate. Seek professional help if necessary.

    Less
    More
    Showing 1 - 23 of 23 items