Motorola Moto Edge 30 Pro spare parts

Technical Characteristics of Motorola Moto Edge 30 Pro Repuestos

The Motorola Moto Edge 30 Pro repuestos are made up of various hardware components that contribute to the phone's overall performance and functionality. Some of the primary parts include:

• Display: 6.7" OLED, 1080 x 2400 pixels, 20:9 ratio (~385 ppi density)
• Battery: Li-Po 5000 mAh, non-removable battery
• Main Camera: Triple set-up - 108 MP, f/1.9, (wide), 1/1.52", 0.7µm| 8 MP, f/2.4, (telephoto), 5x optical zoom| 16 MP, f/2.2, 14mm (ultrawide), 1.0µm
• Selfie Camera: Single set-up - 16 MP, f/2.5, (wide), 1.0µm
• Processor: Qualcomm SM8350 Snapdragon 888 5G (5 nm)
• Memory: 128GB 8GB RAM, 256GB 12GB RAM, UFS 3.1

Instructions on How to Replace Motorola Moto Edge 30 Pro Repuestos

Tools Needed:

Before you begin, make sure you have the following tools Philips head screwdriver, plastic opening tools, tweezers, and a spudger.

Precautions:

Ensure the phone is powered off and disconnected from any power source before starting. Always handle parts and tools with care. It’s also recommended to follow anti-static safety measures to prevent electrostatic discharge that could damage the phone components.

Step-by-Step Guide:

Note that this is a general guide and some steps might vary based on the specific part that you are replacing

• Step 1: Remove the Back Cover

  Use a heat gun to loosen the adhesive that holds the back cover in place. Then, gently pry off the back cover using a plastic opening tool.

• Step 2: Detach the Battery Connector

  Unscrew the shield that covers the battery connector. Then, use a plastic spudger to disconnect the battery connector.

• Step 3: Remove the Defective Part

  Unscrew and carefully remove the defective part. If your part is connected via a cable, use the tweezers to disconnect the cable first.

• Step 4: Install the New Part

  Simply reverse the previous step. Screw the new part into place, and reconnect any cables with tweezers.

• Step 5: Reconnect the Battery

  Plug in the battery connector and screw the shield back into place.

• Step 6: Reattach the Back Cover

  Line up the back cover with the phone, and then apply pressure to snap it back into place. If necessary, use the heat gun to soften the adhesive and ensure a strong seal.