Nothing Phone spare parts

Technical Characteristics of Nothing Phone Spare Parts (Nothing Phone Repuestos)

The Nothing Phone is built with a variety of high-quality components that ensure optimal performance and longevity. Below are the technical specifications of its key spare parts:

• Display: 6.7-inch OLED display, 1080 x 2400 pixels resolution, Corning Gorilla Glass 5 protection
• Battery: 4500mAh Li-Po, non-removable, supports fast charging up to 33W
• Processor: Qualcomm Snapdragon 778G, Octa-core
• RAM: 8GB/12GB LPDDR4X
• Storage: 128GB/256GB UFS 3.1
• Rear Camera: Dual 50MP (wide) + 50MP (ultrawide)
• Front Camera: 32MP
• Operating System: Nothing OS based on Android 12

Instructions for Replacing Nothing Phone Spare Parts

Follow the detailed instructions below to replace specific components of the Nothing Phone safely and effectively.

1. Tools Required

• Spudger
• Pentalobe screwdriver
• Phillips screwdriver
• Plastic opening tool
• Suction cup
• Adhesive strips
• Tweezers
• Heat gun or hair dryer
• Antistatic wrist strap (optional but recommended)

2. Replacing the Battery

• Step 1: Power off the phone and remove the SIM card tray.
• Step 2: Use the pentalobe screwdriver to remove the screws located at the bottom of the device.
• Step 3: Apply heat around the edges of the back cover using a heat gun or hair dryer to soften the adhesive.
• Step 4: Use the suction cup to lift the back cover slightly, and then insert the plastic opening tool to gently pry it off.
• Step 5: Disconnect the battery connector using the spudger.
• Step 6: Remove the adhesive strips that hold the battery in place.
• Step 7: Carefully remove the battery using the spudger and replace it with a new one.
• Step 8: Reconnect the battery connector and reassemble the phone by reversing the steps.

3. Replacing the Display

• Step 1: Ensure the phone is powered off and remove the SIM card tray.
• Step 2: Remove the screws at the bottom part of the device with the pentalobe screwdriver.
• Step 3: Apply heat to the edges of the display using a heat gun or hair dryer to soften the adhesive.
• Step 4: Use the suction cup to create an opening between the display and the frame, then insert the plastic opening tool and gently separate the display from the frame.
• Step 5: Disconnect the display connectors using the spudger.
• Step 6: Remove the old display completely.
• Step 7: Attach the new display by connecting the display connectors.
• Step 8: Gently press the new display into place and reassemble the phone by reversing the steps.

4. Safety Precautions

• Work on a flat, clean surface to avoid losing small parts.
• Use antistatic equipment to avoid damaging the phone’s internal components.
• Take your time to avoid damaging delicate parts.
• If unsure or inexperienced, consider seeking professional help from a certified technician.