Oneplus 9 spare parts

Technical Characteristics of OnePlus 9 Replacement Parts

The OnePlus 9 is a high-end smartphone that requires specific replacement parts to ensure optimal functionality. Below are the key technical characteristics of the most common replacement parts for the OnePlus 9:

Screen

• Type: Fluid AMOLED
• Size: 6.55 inches
• Resolution: 1080 x 2400 pixels
• Features: 120Hz refresh rate, HDR10+

Battery

• Type: Li-Po
• Capacity: 4500 mAh
• Charging: Fast charging 65W, USB Power Delivery

Camera Module

• Main Camera: Triple - 48 MP (wide), 50 MP (ultrawide), 2 MP (monochrome)
• Features: Dual-LED flash, HDR, panorama
• Video: 8K@30fps, 4K@30/60fps, 1080p@30/60/240fps

Back Cover

• Material: Glass
• Features: Gorilla Glass protection

Instructions for Replacing OnePlus 9 Replacement Parts

Replacing parts on a OnePlus 9 requires careful attention and a systematic approach. Below are step-by-step instructions for replacing the screen, battery, and camera module of the OnePlus 9:

Screen Replacement

• Step 1: Power off the device and remove the SIM card tray.
• Step 2: Use a heat gun or a hair dryer to heat the edges of the front screen to loosen the adhesive.
• Step 3: Once the adhesive is warm, use a suction cup to gently lift the screen. Slide a plastic pry tool around the edges to fully detach the screen from the frame.
• Step 4: Disconnect the screen connectors carefully using tweezers.
• Step 5: Remove the old screen and replace it with the new one. Connect all the necessary connectors and ensure they are securely in place.
• Step 6: Apply new adhesive around the frame and carefully place the new screen.
• Step 7: Power on the device to check the functionality of the new screen.

Battery Replacement

• Step 1: Power off the device and remove the back cover by heating the edges and using a plastic pry tool to detach it.
• Step 2: Unscrew all the screws securing the mid-frame and remove it.
• Step 3: Disconnect the battery connector from the motherboard using tweezers.
• Step 4: Carefully pry up the old battery using a plastic card or a similar tool. Avoid using metal tools to prevent damage.
• Step 5: Place the new battery in place of the old one and reconnect the battery connector.
• Step 6: Reassemble the mid-frame and secure it with screws.
• Step 7: Reattach the back cover using new adhesive and press it firmly to ensure it is secure.
• Step 8: Power on the device to check that the new battery is working correctly.

Camera Module Replacement

• Step 1: Power off the device and remove the back cover as previously described.
• Step 2: Locate the camera module and unscrew the screws holding it in place.
• Step 3: Disconnect the connectors attached to the camera module using tweezers.
• Step 4: Remove the old camera module carefully.
• Step 5: Place the new camera module into the slot and reconnect the connectors.
• Step 6: Secure the camera module with the screws.
• Step 7: Reattach the back cover with new adhesive and press it firmly to ensure it is secure.
• Step 8: Power on the device and test the new camera module to ensure it is functioning correctly.