Oneplus Nord 2 5G spare parts

OnePlus Nord 2 5G Replacement Parts Technical Characteristics

Screen

Type: Fluid AMOLED, 90Hz

Size: 6.43 inches

Resolution: 1080 x 2400 pixels

Protection: Corning Gorilla Glass 5

Battery

Type: Li-Po 4500 mAh, non-removable

Charging: Fast charging 65W, 1-100% in 30 min (advertised)

Camera Module

Main Camera: Triple - 50 MP, f/1.9 (wide), 8 MP, f/2.3 (ultrawide), 2 MP, f/2.4 (monochrome)

Front Camera: Single - 32 MP, f/2.5 (wide)

Other Components

SIM Card Tray: Dual SIM (Nano-SIM, dual stand-by)

Charging Port: USB Type-C 2.0, USB On-The-Go

Other: Fingerprint (under display, optical), accelerometer, gyro, proximity, compass

Instructions for Replacing OnePlus Nord 2 5G Parts

Preparation

• Power off your OnePlus Nord 2 5G.
• Gather necessary tools: a precision screwdriver set, plastic opening tools, tweezers, suction cup, and replacement parts.
• Work on a clean, flat surface with adequate lighting.

Replacing the Screen

• Step 1: Remove the SIM tray using the SIM ejector tool.
• Step 2: Unscrew the two screws at the bottom of the phone near the charging port.
• Step 3: Use a suction cup to gently separate the back cover from the phone frame.
• Step 4: Gradually work a plastic opening tool around the edges to unclip the back cover. Take care not to damage any internal components.
• Step 5: Disconnect the battery connector using a plastic tool to avoid short circuits.
• Step 6: Unscrew and remove the metal shields covering the motherboard connectors.
• Step 7: Disconnect the display connector from the motherboard.
• Step 8: Use a heat gun to warm the edges of the screen to soften the adhesive.
• Step 9: Pry up the screen carefully with a plastic opening tool, removing the old screen.
• Step 10: Clean the frame of any adhesive residue and place the new screen aligning it carefully.
• Step 11: Reconnect the display connector and reassemble the phone in reverse order of disassembly.

Replacing the Battery

• Step 1: Follow steps 1 to 5 from the screen replacement instructions to open the device and disconnect the battery.
• Step 2: Locate the pull tabs for the battery adhesive strips.
• Step 3: Gently pull the tabs to loosen the battery adhesive. If necessary, use a spudger to lift the battery.
• Step 4: Insert the new battery and press it firmly to ensure it adheres properly.
• Step 5: Reconnect the battery connector and reassemble the phone.

Replacing the Camera Module

• Step 1: Follow steps 1 to 5 from the screen replacement instructions to access the internals.
• Step 2: Disconnect the camera module connectors from the motherboard.
• Step 3: Remove any screws or clips holding the camera modules in place.
• Step 4: Carefully remove the old camera modules.
• Step 5: Place the new camera modules in position and secure them with screws or clips.
• Step 6: Reconnect the camera module connectors to the motherboard.
• Step 7: Reassemble the phone in the reverse order of disassembly.

Ensure each replacement part is firmly connected and test the device thoroughly before fully reassembling.