Oppo A57 spare parts

Technical Characteristics of Oppo A57 Repuestos

The Oppo A57 is engineered with various replaceable parts, known as repuestos, to ensure longevity and proper functionality of the device. Below are the primary technical characteristics of these repuestos:

• Display: 5.2-inch IPS LCD with a resolution of 720 x 1280 pixels.
• Battery: 2900 mAh Li-Ion, non-removable.
• Camera:
  • Rear: 13 MP, f/2.2, autofocus, and LED flash.
  • Front: 16 MP, f/2.0.
• Chipset: Qualcomm MSM8940 Snapdragon 435.
• Internal Memory: 32 GB, with 3 GB RAM.
• Operating System: Android 6.0 (Marshmallow), ColorOS 3.0.

Instructions on How to Replace Oppo A57 Repuestos

Tools Required:

• Phillips #00 Screwdriver
• Plastic Pry Tools
• Tweezers
• Suction Cup
• SIM Eject Tool
• Anti-static wrist strap (recommended)

Step-by-Step Instructions:

Battery Replacement:

• Power off the device completely.
• Remove the SIM card tray using the SIM eject tool.
• Use a Phillips #00 screwdriver to remove the screws at the bottom of the phone.
• Apply a suction cup to the lower edge of the front screen to gently lift the screen assembly.
• Insert a plastic pry tool between the screen and the rear case.
• Carefully slide the pry tool around the edges to release the clips securing the screen to the rear case.
• Detach the screen gently and do not pull it away completely; it is still connected by flex cables.
• Remove the screws securing the metal bracket covering the battery connector.
• Disconnect the battery connector using tweezers.
• Lift the battery pull tab and carefully remove the battery.
• Replace the old battery with a new one, ensuring it sits properly in its place.
• Reconnect the battery connector and replace the metal bracket.
• Reassemble the device by following the above steps in reverse order.

Screen Replacement:

• Follow the initial steps for removing the battery as outlined above until you have detached the screen assembly.
• Disconnect the screen cables gently from the motherboard.
• Take note of the connection points for the new screen assembly.
• Connect the new screen assembly cables to the appropriate slots on the motherboard.
• Test the new screen to ensure it functions correctly before fully reassembling.
• After confirming the new screen is working, reassemble the device by following the reverse steps of disassembly.

Ensure to power on the device after reassembly to verify successful component replacement. If the device does not turn on, double-check all connections.