Oppo A73 2020 spare parts

Technical Characteristics of Oppo A73 2020 Components

1. Display

Size: 6.44 inches

Type: AMOLED, Capacitive Touchscreen

Resolution: 1080 x 2400 pixels

2. Battery

Type: Non-removable Li-Po 4015 mAh battery

Charging: Fast charging 30W, 50% in 30 min

3. Camera

Rear Camera: Quad 16 MP + 8 MP + 2 MP + 2 MP

Front Camera: Single 16 MP

4. Processor

CPU: Octa-core (4x2.0 GHz Kryo 260 Gold & 4x1.8 GHz Kryo 260 Silver)

GPU: Adreno 610

5. Storage

Internal: 128GB

RAM: 6GB

Expandable: microSDXC (dedicated slot)

Instructions to Replace Oppo A73 2020 Components

1. Tools Required

• Pry tool
• Small Phillips screwdriver
• Suction cup tool
• Plastic card
• Tweezers
• Heat gun or hairdryer
• ESD-safe opening tool

2. General Safety Precautions

• Power off the device before starting any repair.
• Use ESD-safe tools to avoid damage from static electricity.
• Keep track of all screws and components removed during disassembly.

3. Replacing the Display

• Heat the edges of the display using a heat gun or hairdryer to soften the adhesive.

• Use a suction cup to lift a corner of the display gently.

• Insert a pry tool or plastic card into the gap and carefully slide it around the edges to release the adhesive.

• Disconnect the display connector by removing any screws and using a pry tool to lift the connector.

• Replace with new display by connecting the display connector back and securing any screws.

• Press gently around the edges to secure the new display in place.

4. Replacing the Battery

• Remove the back cover using a pry tool. Use the heat gun if necessary to loosen the adhesive.

• Disconnect the battery connector.

• Use a pry tool to slowly lift the battery out of its compartment. Be careful not to puncture the battery.

• Place the new battery in and reconnect the battery connector.

• Secure the back cover in place by pressing it gently until it clicks.

5. Replacing the Camera

• Remove the back cover using a pry tool. Apply heat if necessary to loosen the adhesive.

• Remove the screws securing the camera module and disconnect the camera connector.

• Lift the old camera module out using tweezers.

• Place the new camera module in its position and reconnect the camera connector.

• Secure the camera module with screws.

6. Final Steps

• Make sure all connectors are securely reconnected.
• Reassemble the back cover and ensure it clicks into place.
• Power on the device to test the new components.