Oppo Find N2 Flip spare parts

Technical Characteristics of Oppo Find N2 Flip Repuestos

The Oppo Find N2 Flip is designed with a range of high-quality components and parts, often referred to as repuestos. These repuestos include:

• Screen: 6.8-inch AMOLED, 1080 x 2520 pixels resolution.
• Battery: 4300 mAh, non-removable Li-Po battery.
• CPU: Octa-core processor setup.
• Camera: Triple-camera setup with 50 MP (wide), 12 MP (ultrawide), and 5 MP (macro).
• Storage: Options of 256GB/512GB internal memory with 8GB/12GB RAM.
• Operating System: Android-based ColorOS.
• Ports and Buttons: USB Type-C port, volume buttons, power button with fingerprint sensor.

Instructions on How to Replace Oppo Find N2 Flip Repuestos

1. Battery Replacement

• Power off your Oppo Find N2 Flip and remove the SIM card tray.
• Heat the back cover using a heat gun or hairdryer to loosen the adhesive.
• Use a suction cup to lift the back cover and a plastic pry tool to separate it from the frame.
• Remove the screws securing the battery connector cover and carefully disconnect the battery connector.
• Peel off the adhesive strips holding the battery in place and remove the old battery.
• Place the new battery into the compartment and reconnect the battery connector.
• Reassemble the phone by reversing the steps, ensuring all screws are tightened and adhesives are secure.
• Power on the device to test the new battery.

2. Screen Replacement

• Power off the device and remove the SIM card tray.
• Heat the edges of the screen using a heat gun or hairdryer to soften the adhesive.
• Use a suction cup to lift the screen slightly, and insert a plastic pry tool to separate the screen from the frame.
• Disconnect the display connector once the screen is lifted.
• Remove the old screen and replace it with the new one by connecting it to the display connector.
• Carefully align the new screen with the frame and press down to secure it to the adhesive.
• Power on the device to test the new screen.

3. Camera Replacement

• Power off the device and remove the SIM card tray.
• Heat the back cover using a heat gun or hairdryer to loosen the adhesive.
• Use a suction cup to lift the back cover and a plastic pry tool to separate it from the frame.
• Disconnect the camera module connectors.
• Remove the screws and gently lift out the old camera module.
• Install the new camera module, reattach the connectors, and secure it with screws.
• Reassemble the phone by reversing the steps, ensuring all screws are tightened and adhesives secure.
• Power on the device to test the new camera module.