Oppo Find X2 Lite spare parts

Technical Characteristics of Oppo Find X2 Lite Repuestos

1. Display

Type: AMOLED

Size: 6.4 inches, 100.5 cm2 (~84.3% screen-to-body ratio)

Resolution: 1080 x 2400 pixels, 20:9 ratio (~411 ppi density)

Protection: Corning Gorilla Glass 5

2. Battery

Type: Li-Po 4025 mAh, non-removable

Charging: Fast charging 30W, 50% in 20 min

3. Camera

Primary: Quad 48 MP, f/1.7, 26mm (wide), 1/2.0"", 0.8µm, PDAF

Selfie: Single 32 MP, f/2.0, 26mm (wide), 1/2.8"", 0.8µm

4. Other Key Components

Chipset: Qualcomm SDM765 Snapdragon 765G (7 nm)

CPU: Octa-core (1x2.4 GHz Kryo 475 Prime & 1x2.2 GHz Kryo 475 Gold & 6x1.8 GHz Kryo 475 Silver)

GPU: Adreno 620

Storage: 128GB, 8GB RAM

Instructions for Replacing Oppo Find X2 Lite Repuestos

1. Tools Required

• Phillips head screwdriver
• Plastic opening tools
• Suction cup
• Tweezers
• Heat gun or hairdryer
• Adhesive strips

2. Steps to Replace the Display

• Power off the Oppo Find X2 Lite and remove the SIM card tray.
• Use a heat gun or hairdryer to gently heat the edges of the screen to soften the adhesive.
• Place a suction cup near the edge of the screen to lift the display slightly.
• Insert a plastic opening tool into the gap and slowly work your way around the device to detach the display.
• Once the display is loose, carefully lift it away from the device, ensuring not to damage the ribbon cables.
• Disconnect the ribbon cables connecting the display to the motherboard using tweezers.
• Remove the old display and replace it with the new one.
• Reconnect the ribbon cables to the motherboard, ensuring they are firmly in place.
• Carefully align the new display and press it into place, ensuring the adhesive is secure.
• Turn on the device to check the new display functionality.
• If everything works correctly, reinsert the SIM card tray.

3. Steps to Replace the Battery

• Power off the Oppo Find X2 Lite and remove the SIM card tray.
• Use a heat gun or hairdryer to gently heat the back cover to soften the adhesive.
• Use a suction cup to lift the back cover slightly, then insert a plastic opening tool to release the adhesive.
• Once the back cover is removed, unscrew the screws securing the battery connector shield using a Phillips head screwdriver.
• Disconnect the battery connector using tweezers or a plastic tool.
• Lift the adhesive pull tabs to remove the battery from the device. If the adhesive is stubborn, use a heat gun to soften it.
• Place the new battery into the compartment and connect the battery connector.
• Secure the battery connector shield with the screws you previously removed.
• Reattach the back cover by gently pressing it into place, ensuring the adhesive is secure.
• Turn on the device to check the new battery functionality.
• If everything works correctly, reinsert the SIM card tray.