Oppo Realme X50 5G spare parts

Technical Characteristics of Oppo Realme X50 5G Repuestos

The Oppo Realme X50 5G is a mid-range smartphone with impressive features. Here are the technical characteristics of its repuestos (spare parts):

• Screen: 6.57 inches, 1080 x 2400 pixels, IPS LCD
• Battery: Non-removable Li-Po 4200 mAh battery
• Processor: Qualcomm Snapdragon 765G
• Memory: 6GB/8GB RAM, 128GB Storage
• Camera: Quad rear - 64 MP (wide), 12 MP (telephoto), 8 MP (ultrawide), 2 MP (macro); Dual front - 16 MP (wide), 8 MP (ultrawide)
• Connectivity: 5G, Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 5.0, USB Type-C

Instructions on How to Replace Oppo Realme X50 5G Repuestos

1. Replacing the Screen

• Power off the device.
• Remove the SIM card tray using a SIM ejector tool.
• Use a heat gun or hairdryer to heat the edges of the screen for about 2-3 minutes to loosen the adhesive.
• Carefully use a plastic prying tool to lift the screen starting from a corner. Slide the tool around the edges to separate the screen from the frame.
• Disconnect the display cables gently to fully detach the screen. Set the old screen aside.
• Connect the new screen's cables to the motherboard.
• Align the new screen with the frame and gently press it into place. Ensure it fits securely without any gaps.
• Reinsert the SIM card tray and power on the device to test the new screen.

2. Replacing the Battery

• Power off the device.
• Remove the SIM card tray using a SIM ejector tool.
• Use a heat gun or hairdryer to warm the back panel edges for about 2-3 minutes.
• Utilize a plastic prying tool to carefully lift and remove the back panel.
• Detach the battery connector using a plastic spudger to avoid short circuits.
• Gently pull the adhesive tabs to detach the battery from the housing. If it's stuck, consider using some isopropyl alcohol to weaken the adhesive.
• Remove the old battery and set it aside.
• Place the new battery in its position and connect the battery connector to the motherboard.
• Reattach the back panel, ensuring it fits snugly, and power on the device to ensure functionality.

3. Replacing the Camera Module

• Power off the device.
• Remove the SIM card tray using a SIM ejector tool.
• Utilize a heat gun or hairdryer to warm the back panel edges for about 2-3 minutes.
• Use a plastic prying tool to carefully remove the back panel.
• Locate the camera module and disconnect its connector using a plastic spudger.
• Remove the screws securing the camera module (if any) and gently lift it out of the housing.
• Place the new camera module in position and secure it with screws if applicable.
• Reconnect the camera module connector to the motherboard.
• Reattach the back panel, ensuring it is securely in place, and power on the device to test the new camera.