Oppo Reno 11 spare parts

Technical Characteristics of Oppo Reno 11 Repuestos

Below are the detailed technical characteristics of the Oppo Reno 11 replacement parts (repuestos):

• LCD Display: 6.5 inches, 1080 x 2400 pixels, OLED
• Battery: Li-Po 4500 mAh, non-removable
• Rear Camera: 64MP (wide), 8MP (ultrawide), 2MP (macro)
• Front Camera: 32MP
• Processor: Qualcomm Snapdragon 888 or better
• Memory: 8GB RAM, 128/256GB internal storage
• Operating System: Android 11, ColorOS 11.1
• Connectivity: 5G support, Wi-Fi 6, Bluetooth 5.2
• Other Components: Fingerprint sensor (under display), accelerometer, gyro, proximity, compass, color spectrum

Instructions for Replacing Oppo Reno 11 Repuestos

Follow these detailed instructions carefully to replace various components of the Oppo Reno 11:

Tools Needed:

• Phillips #00 Screwdriver
• Plastic Pry Tools
• Suction Cup
• Tweezers
• SIM Card Ejector Tool
• Heat Gun or iOpener
• ESD-Safe Mat
• Anti-Static Wrist Strap

Step-by-Step Instructions:

Step 1: Power Off the Phone

Ensure the phone is completely powered off before you begin any repair.

Step 2: Remove the SIM Card Tray

Insert the SIM card ejector tool into the small hole on the SIM card tray. Apply pressure to eject the tray.

Step 3: Heat the Back Cover

Use a heat gun or an iOpener to soften the adhesive on the back cover. Apply heat evenly around the edges for a few minutes.

Step 4: Pry Open the Back Cover

Once the adhesive is softened, use a suction cup to lift the back cover slightly, creating a gap. Insert a plastic pry tool into the gap and gently work your way around the edges to remove the back cover.

Step 5: Disconnect the Battery

• Use a Phillips #00 screwdriver to remove the screws securing the battery connector shield.
• Carefully lift the battery connector shield using tweezers.
• Use a plastic pry tool to disconnect the battery connector from the motherboard.

Step 6: Remove the Old Component and Install the New One

• For Screen Replacement: Disconnect the display cables from the motherboard, remove the old display, and carefully align and connect the new display cables. Secure the new display using appropriate adhesive.
• For Battery Replacement: Use the plastic pry tool to lift the battery out of its compartment. Insert the new battery and reconnect it to the motherboard.
• For Camera Replacement: Use a Phillips #00 screwdriver to remove screws securing the camera module. Disconnect the camera module from the motherboard and replace it with the new one.

Step 7: Reassemble the Phone

• Reconnect any cables you had to disconnect during the replacement process.
• Reattach the battery connector shield using the screws you removed earlier.
• Align the back cover and press it firmly into place. If necessary, reapply heat to soften the adhesive again for a secure fit.

Step 8: Power On the Phone and Test

Once the phone is reassembled, power it on to ensure all components are working correctly.

Congratulations! You have successfully replaced the necessary components in your Oppo Reno 11.