Oppo Reno 2 repuestos

Oppo Reno 2 Technical Characteristics and Replacement Instructions

Technical Characteristics of Oppo Reno 2 Repuestos

Below are the technical characteristics of various Oppo Reno 2 replacement parts:

• Display: 6.5 inch AMOLED, resolution of 2400 x 1080 pixels
• Processor: Qualcomm Snapdragon 730G
• Rear Camera: Quad camera setup (48MP + 13MP + 8MP + 2MP)
• Front Camera: 16 MP motorized pop-up
• Battery: 4000 mAh with VOOC Flash Charge 3.0
• Operating System: Android 9.0 (Pie), upgradable to Android 10
• Memory: 8GB RAM and 256GB internal storage

Instructions for Replacing Oppo Reno 2 Repuestos

Follow the instructions below to replace parts in your Oppo Reno 2:

Replacing the Screen

• Power off the device and remove the SIM card tray using a SIM ejector tool.
• Use a heat gun or hairdryer to soften the adhesive around the edges of the back cover.
• Gently use a plastic tool to pry open the back cover, starting from one corner and working your way around.
• Carefully disconnect the battery flex cable using a spudger.
• Unscrew the screws securing the motherboard shield and gently remove the shield.
• Disconnect the display connector from the motherboard.
• Use a plastic pry tool to separate the screen assembly from the middle frame.
• Reassemble the new screen by reversing these steps, ensuring all connectors are securely in place.
• Power on the device to ensure the screen is operating correctly before sealing the back cover.

Replacing the Battery

• Power off the device and remove the SIM card tray.
• Follow the steps to remove the back cover as described in the screen replacement section.
• Carefully disconnect the battery flex cable from the motherboard using a spudger.
• Use a pull-tab located under the battery or, if not available, gently pry the battery out without bending it.
• Replace the old battery with the new one, making sure to connect the flex cable properly.
• Reassemble the device by reversing the disassembly steps and ensure that all screws and connectors are tight.
• Turn on the device to ensure that the new battery is functioning correctly.

Replacing the Rear Camera

• Power off the device and remove the SIM card tray.
• Follow the steps to remove the back cover as described in the screen replacement section.
• Disconnect the battery flex cable and other connectors related to the camera assembly using a spudger.
• Unscrew the screws holding the camera module in place.
• Carefully remove the old camera module and replace it with the new one.
• Reconnect all flex cables, ensuring they are securely attached to the motherboard.
• Reassemble the device and turn it on to test the new camera functionality.

Note: Always handle internal components with care to avoid damage. If uncertain, seek assistance from a professional technician.