Oppo Reno 2Z repuestos

Technical Characteristics of Oppo Reno 2Z Repuestos

The Oppo Reno 2Z is a feature-packed smartphone that boasts impressive technical specifications. Below are some of the key characteristics of the Oppo Reno 2Z repuestos (spare parts):

• Display: 6.53 inches AMOLED, with a resolution of 1080 x 2340 pixels
• Processor: MediaTek MT6779 Helio P90 (12 nm)
• RAM: 8GB
• Storage: 128GB/256GB
• Camera: Quad camera setup (48MP + 8MP + 2MP + 2MP)
• Battery: 4000mAh, non-removable
• Operating System: Android 9.0 (Pie), upgradable to Android 10
• Other Features: Fingerprint sensor (under display), fast charging 20W (VOOC 3.0)

Instructions on How to Replace Oppo Reno 2Z Repuestos

Tools Required

• Plastic Pry Tool
• Phillips #000 Screwdriver
• Suction Cup
• Plastic Cards
• Spudger
• Tweezers

Step-by-Step Instructions

1. Power Off the Device: Ensure the Oppo Reno 2Z is completely powered off before starting any repair process.

2. Remove the SIM Card Tray: Use a SIM card ejection tool to remove the SIM card tray from the device.

3. Open the Back Cover:

• Use a suction cup to create a gap between the back cover and the frame.
• Insert a plastic pry tool into the gap and carefully slide it around the edges to detach the clips holding the back cover in place.
• Lift the back cover gently to avoid damaging the fingerprint sensor cable, if applicable.

4. Disconnect the Battery: Use the Phillips #000 screwdriver to remove the screws securing the battery connector shield. Then, use a spudger to disconnect the battery connector.

5. Replace the Display Assembly:

• Disconnect the display connectors using the spudger.
• Remove any screws securing the display assembly to the frame.
• Heat the edges of the display using a heat gun or hairdryer to soften the adhesive.
• Insert a plastic card or pry tool between the display and the frame, gently prying it off.
• Attach the new display assembly and reconnect all necessary connectors and screws.

6. Reassemble the Device:

• Reconnect the battery and secure it with the previously removed screws.
• Replace the back cover by aligning it with the frame and pressing firmly around the edges to ensure the clips are engaged.
• Reinsert the SIM card tray.

7. Power On the Device: Turn on the Oppo Reno 2Z to ensure all replaced components are working correctly.