Oppo Reno Z spare parts

Technical Characteristics of Oppo Reno Z Spare Parts

1. Display

Size: 6.4 inches

Type: AMOLED

Resolution: 1080 x 2340 pixels

2. Battery

Capacity: 4035 mAh

Type: Non-removable Li-Po

3. Camera

Primary: 48 MP, f/1.7, 26mm (wide), 1/2"", 0.8µm, PDAF

Secondary: 5 MP, f/2.4, 1/5"", 1.12µm, depth sensor

Front Camera: 32 MP, f/2.0, 26mm (wide)

4. Processor

Type: Mediatek MT6779 Helio P90

5. Memory

Internal: 128GB 4GB RAM, 128GB 8GB RAM

Card Slot: No

6. OS

Type: Android 9.0 (Pie); ColorOS 6.1

7. Other Components

SIM: Dual SIM (Nano-SIM, dual stand-by)

Instructions on How to Replace Oppo Reno Z Spare Parts (Repuestos)

1. Safety Precautions

• Turn off the device and unplug it from any power source.
• Use an anti-static wrist strap to prevent any damage from electrostatic discharge.
• Work in a clean, well-lit environment.

2. Required Tools

• Phillips head screwdriver
• Pry tool or plastic opening tool
• Tweezers
• Suction cup (for display removal)
• Adhesive strips or double-sided tape (for display replacement)

3. Replacing the Display

• Turn off your Oppo Reno Z and remove the SIM card using a SIM card ejector tool.
• Use a pry tool to gently remove the back cover of the device.
• Remove the screws securing the battery and display connectors using a Phillips screwdriver.
• Disconnect the battery to prevent any short circuits.
• Use a suction cup to lift the old display from the frame, applying gentle pressure to avoid breaking it.
• Carefully disconnect the display cable using tweezers.
• Connect the new display to the display cable and place it in the frame.
• Reattach the battery and secure it with the screws.
• Power on the device to test if the new display is functioning correctly.
• Replace the back cover and SIM card.

4. Replacing the Battery

• Turn off your device and remove the back cover.
• Unscrew the screws securing the battery connector.
• Disconnect the battery and use a pry tool to gently lift it out of the device.
• Place the new battery in position and connect it to the battery connector.
• Secure the connector with screws.
• Power on the device to ensure it functions properly with the new battery.
• Replace the back cover.

5. Replacing the Camera Module

• Remove the back cover and disconnect the battery as previously described.
• Locate the camera module and unscrew the screws securing it to the motherboard.
• Disconnect the camera module from the motherboard connector.
• Connect the new camera module and secure it with screws.
• Reconnect the battery and replace the back cover.
• Turn on the device to test the new camera module.