Oukitel C32 spare parts

Technical Characteristics of Oukitel C32 Spare Parts

Model: Oukitel C32

Screen Size: 6.5 inches

Screen Resolution: 720 x 1600 pixels

Battery Capacity: 4000mAh

Processor: Quad-core 1.3 GHz

RAM: 3GB

Storage: 32GB internal, expandable up to 128GB via microSD

Rear Camera: 13 MP

Front Camera: 5 MP

Operating System: Android 11

Instructions on How to Replace Oukitel C32 Spare Parts

1. Preparation

• Power off the phone completely.
• Gather essential tools: a small Phillips screwdriver, plastic opening tools, tweezers, and a suction cup if needed.
• Make sure you have the appropriate replacements parts such as the screen, battery, or other necessary components.

2. Removing the Back Cover

• Using a plastic opening tool, gently work your way around the edges of the phone to unclip the back cover. Be careful not to damage the clips.
• Once unclipped, gently lift the back cover and set it aside.

3. Disconnecting the Battery

• Locate the battery connector on the motherboard. Use a plastic tool to gently pry it off the socket.
• Make sure to handle the connector carefully to avoid damaging the socket on the motherboard.
• If replacing the battery: Remove any adhesives holding the battery in place, then carefully lift the battery out of the housing. Place the new battery and reconnect the battery connector.

4. Replacing the Screen

• Remove the screws securing the internal frame or shield above the screen connectors.
• Gently disconnect the screen flex cable using a plastic tool.
• Use a suction cup to gently lift the screen while inserting a plastic opening tool around the edges to release the adhesive.
• Install the new screen by aligning it properly and connecting the flex cable back to the motherboard.
• Reattach the internal frame or shield and secure it with screws.

5. Reassembly

• Double-check all connections ensuring that every flex cable and connector is properly seated.
• Place the back cover back onto the phone and press down gently but firmly to clip it back into place.
• Power on the phone to verify that the new parts are functioning correctly.