Oukitel C36 spare parts

Technical Characteristics of Oukitel C36 Repuestos

General

The Oukitel C36 is equipped with various components known for their reliability and performance. Below are the technical characteristics of its main repuestos (spare parts):

• Screen: 6.095 inches, HD+ resolution, 720 x 1560 pixels
• Battery: 4750 mAh, Li-Po
• Camera: Dual rear camera, 8 MP main sensor + 2 MP secondary sensor; 5 MP front camera
• Processor: Quad-core Cortex-A53
• RAM: 3 GB
• Storage: 32 GB, expandable via microSD
• Operating System: Android 11

Instructions for Replacing Oukitel C36 Repuestos

Tools Required

• Phillips screwdriver
• Plastic opening tools
• Suction cup
• Tweezers
• Adhesive tape
• Heat gun (optional)

Step-by-Step Instructions

1. Power Off the Device

Ensure the Oukitel C36 is powered off completely before starting any replacement procedure.

2. Remove the Back Cover

Using a plastic opening tool, gently pry around the edges of the back cover to release the clips holding it in place. Carefully lift off the back cover.

3. Disconnect the Battery

Locate the battery connector and use the plastic opening tool to disconnect it from the motherboard to prevent any electrical damage.

4. Remove the Battery

If replacing the battery, use the plastic tool to gently lift the battery from its adhesive. Be cautious to avoid puncturing the battery.

5. Remove Screws

Using a Phillips screwdriver, remove all screws securing the middle frame or any shields covering the internal components.

6. Disconnect Connectors

Use tweezers or a plastic tool to disconnect all flex cables, connectors, and antenna cables attached to the motherboard or other internal components.

7. Remove the Motherboard

Gently lift the motherboard out of the device using plastic tools, taking care not to damage any connectors or surrounding components.

8. Replace the Desired Component

Whether it is the screen, camera, charging port, or other components, carefully remove the defective part and replace it with a new one, securing it in place as necessary.

9. Reassemble the Device

• Reattach the motherboard and secure it with screws.
• Reconnect all flex cables, connectors, and antenna cables.
• Reinsert and connect the battery.
• Reattach the middle frame or shields if any.
• Snap the back cover back into place.

10. Testing

Power on the device and test the functionality of the replaced components to ensure everything is working properly.