Oukitel K13 Pro spare parts

Oukitel K13 Pro Technical Characteristics and Replacement Instructions

Technical Characteristics of Oukitel K13 Pro Repuestos

The Oukitel K13 Pro is equipped with several replaceable parts (repuestos) that contribute to its power and functionality. Below are some of the key components:

• Battery: 11000mAh high-capacity lithium polymer battery
• Screen: 6.41-inch FHD+ display with a resolution of 2340x1080 pixels
• Camera: Front camera 8MP; Rear cameras 16MP + 2MP
• Processor: MediaTek Helio P22 Octa-core
• Internal Storage: 4GB RAM + 64GB ROM, expandable by microSD
• Operating System: Android 9.0 Pie

Instructions for Replacing Oukitel K13 Pro Repuestos

Replacing the components of the Oukitel K13 Pro requires precision and care. Ensure you have the necessary tools ready before proceeding: a small Phillips screwdriver, plastic opening tools, tweezers, and replacement parts.

Battery Replacement

Steps to replace the battery:

• 1. Turn off the phone: Ensure your Oukitel K13 Pro is completely powered off to avoid any short circuits.
• 2. Remove the back cover: Use a plastic opening tool to gently pry open the back cover. Start from one corner and slowly work your way around the edges.
• 3. Disconnect the battery connector: Locate the battery connector and use tweezers to gently disconnect it from the motherboard.
• 4. Remove the old battery: Gently lift the battery using a plastic tool. Be careful not to puncture or bend the battery.
• 5. Install the new battery: Place the new replacement battery into the slot and reconnect the battery connector to the motherboard.
• 6. Reattach the back cover: Align the back cover with the edges and gently press it down until it clicks into place.
• 7. Turn on your device: Power up your Oukitel K13 Pro to ensure the new battery is functioning correctly.

Screen Replacement

Steps to replace the screen:

• 1. Power off the phone: Make sure the device is turned off before proceeding.
• 2. Remove the back cover: Use a plastic opening tool to carefully open the back cover.
• 3. Disconnect the battery: Safely disconnect the battery to prevent any power from going to the components.
• 4. Remove the screws: Use a small Phillips screwdriver to remove the screws securing the internal components.
• 5. Disconnect the screen connectors: Locate and disconnect the screen connectors from the motherboard.
• 6. Remove the damaged screen: Carefully lift and remove the damaged screen from the front of the device.
• 7. Install the new screen: Place the new screen in position and reconnect the screen connectors to the motherboard.
• 8. Reassemble the device: Replace all screws, reconnect the battery, and secure the back cover.
• 9. Turn on the device: Power on the phone to check if the new screen is working correctly.