Oukitel K6 spare parts

Oukitel K6 Technical Characteristics

The Oukitel K6 is a robust smartphone known for its powerful battery and impressive hardware specifications. Below are the technical characteristics of its key components:

• Display: 6.0 inches, 1080x2160 pixels
• Processor: MediaTek Helio P23
• RAM: 6GB
• Storage: 64GB, expandable via microSD
• Rear Camera: Dual 21MP + 8MP
• Front Camera: Dual 13MP + 8MP
• Battery: 6300mAh
• Operating System: Android 7.1
• SIM: Dual SIM (Nano-SIM, dual stand-by)
• Sensors: Fingerprint (rear-mounted), accelerometer, gyro, proximity, compass

Replacement Instructions for Oukitel K6

Follow these detailed instructions carefully to replace parts on your Oukitel K6:

Tools needed:

• Plastic Pry Tools
• Small Phillips Screwdriver
• SIM Ejector Tool
• Tweezers
• Suction Cup
• Adhesive Tape (for reassembly)
• Heat Gun or Hair Dryer (for softening adhesive)

Steps to Replace the Battery:

• Step 1: Power off your phone and remove the SIM card tray using the SIM ejector tool.
• Step 2: Use the heat gun or hair dryer to warm the edges of the back cover to soften the adhesive.
• Step 3: Insert a plastic pry tool between the back cover and the frame, gently working your way around to release the clips holding the cover in place.
• Step 4: Once the back cover is removed, locate the battery connector on the motherboard and disconnect it using a plastic tool to avoid any electrical damage.
• Step 5: Remove any screws securing the battery in place using the Phillips screwdriver.
• Step 6: Carefully lift and remove the battery from the phone. If the battery is glued in place, use the plastic pry tool to separate it gently.
• Step 7: Place the new battery in the compartment, securing it with screws and reconnecting the battery connector.
• Step 8: Reapply adhesive tape to the back cover and press it firmly to secure it back in place.
• Step 9: Reinsert the SIM card tray and power on the phone to confirm that it is functioning correctly.

Steps to Replace the Screen:

• Step 1: Start by powering off the phone and removing the SIM card tray using the SIM ejector tool.
• Step 2: Use a heat gun or hair dryer to warm the edges of the screen to soften the adhesive.
• Step 3: Use a suction cup to lift the screen slightly, and then insert a plastic pry tool around the edges to separate the screen from the frame.
• Step 4: Disconnect the display connectors carefully using tweezers to avoid damaging other components.
• Step 5: Remove the broken screen completely and set it aside.
• Step 6: Align the new screen with the frame and connect the display cables securely.
• Step 7: Carefully press the new screen into place, ensuring that all edges are properly aligned and adhered.
• Step 8: Reinsert the SIM card tray and power on the phone to check the new screen's functionality.