Oukitel K6000 Plus spare parts

Technical Characteristics of Oukitel K6000 Plus Repuestos

The Oukitel K6000 Plus is a robust smartphone known for its impressive battery life and solid performance. Repuestos (replacement parts) for this model maintain high quality and are designed to ensure compatibility and optimal performance. Below are the technical characteristics of some key repuestos:

Battery

• Type: Li-Po 6080 mAh, non-removable
• Voltage: 3.8V
• Stand-by Time: Up to 365 hours
• Talk Time: Up to 46 hours

Screen

• Type: IPS LCD capacitive touchscreen
• Size: 5.5 inches
• Resolution: 1080 x 1920 pixels
• Protection: Dragontrail Glass

Camera Module

• Primary: 16 MP, phase detection autofocus, dual-LED flash
• Secondary: 8 MP

Instructions for Replacing Oukitel K6000 Plus Repuestos

Replacing parts on the Oukitel K6000 Plus requires precision and attention to detail. Below are detailed instructions for replacing some common parts:

Battery Replacement

• Power off the device and remove the SIM card tray.
• Use a plastic opening tool to gently pry open the back cover.
• Locate the battery connector and carefully disconnect it using a pair of tweezers.
• Use a plastic card to lift the battery from the adhesive, starting from one edge.
• Once removed, position the new battery and reconnect the battery connector.
• Reattach the back cover and power on the device to ensure proper installation.

Screen Replacement

• Power off the phone and remove the SIM card tray.
• Remove the screws securing the back cover using a precision screwdriver.
• Gently pry open the back cover with a plastic opening tool.
• Disconnect the battery to avoid any short circuits.
• Locate and disconnect the screen ribbon cable from the motherboard.
• Use a heat gun or hairdryer to warm the screen edges, softening the adhesive.
• Use a plastic card to carefully separate the screen from the frame.
• Once the screen is removed, apply adhesive to the frame and place the new screen.
• Reconnect the screen ribbon cable and the battery.
• Reattach the back cover and screws, then power on the device to check the new screen.

Camera Module Replacement

• Power off the device and remove the SIM card tray.
• Use a plastic opening tool to carefully pry off the back cover.
• Disconnect the battery connector to prevent any short-circuiting.
• Locate the camera module and gently disconnect its ribbon cable from the motherboard.
• Remove the screws securing the camera module, if present.
• Gently lift the old camera module out of its socket.
• Align and place the new camera module in the socket and secure it with screws if applicable.
• Reconnect the camera ribbon cable and the battery connector.
• Reattach the back cover and power on the device to test the new camera module.