Oukitel Mix 2 spare parts

Technical Characteristics of Oukitel Mix 2 Repuestos

Brand: Oukitel

Model: Mix 2

Screen: 5.99 inches, 2160 x 1080 pixels

Processor: MediaTek Helio P25

RAM: 6GB

Storage: 64GB

Battery: 4080mAh

Operating System: Android 7.0

Rear Camera: Dual 21MP + 2MP

Front Camera: 13MP

Instructions for Replacing Oukitel Mix 2 Repuestos

Step 1: Gather Required Tools

• Small Phillips screwdriver
• Plastic opening tools
• Suction cup
• Tweezers
• Plastic card
• Replacement part (screen, battery, etc.)

Step 2: Power Off the Device

Ensure the Oukitel Mix 2 is completely powered off before beginning the repair.

Step 3: Remove the Back Cover

Use a suction cup to lift the back cover gently. Insert a plastic opening tool into the seam to detach the cover slowly. Be careful not to damage the clips that hold the cover in place.

Step 4: Disconnect the Battery

Locate the battery connector and use a plastic tool to disconnect it from the motherboard. This step is crucial to avoid any electrical damage during the repair.

Step 5: Remove the Damaged Part

Depending on the part you are replacing, such as the screen or battery, carefully unscrew and detach the component. Use tweezers to handle small screws and connectors.

• For Screen Replacement: Detach the flex cables and remove any screws holding the screen assembly. Use a plastic card to separate the screen from the frame gently.
• For Battery Replacement: Carefully lift the battery using a plastic tool, being cautious not to puncture or bend it.

Step 6: Install the New Part

Align the new component with the corresponding slots and connectors. Ensure all screws and connectors are securely fastened.

Step 7: Reassemble the Device

Reconnect the battery and other disconnected cables. Snap the back cover into place and ensure it is securely attached.

Step 8: Power On and Test

Power on the Oukitel Mix 2 and verify that the replaced part is functioning correctly. Check for any operational issues before concluding the repair.

Step 9: Final Checks

Ensure that all screws are tightened and that the device is fully operational. Test all functionalities, including touch response, battery charging, and camera operation.