Oukitel WP2 spare parts

Oukitel WP2 Technical Characteristics

The Oukitel WP2 is a rugged smartphone designed to withstand tough environments. Below are its key technical characteristics:

• Display: 6.0 inch IPS LCD, 1080 x 2160 pixels
• Processor: MediaTek MT6750T Octa-core 1.5 GHz
• RAM: 4GB
• Storage: 64GB (expandable via microSD)
• Battery: 10000 mAh, non-removable
• Camera: Dual 16 MP + 2 MP rear cameras, 8 MP front camera
• Operating System: Android 8.0 (Oreo)
• Waterproof Rating: IP68

How to Replace Oukitel WP2 Repuestos

Replacing parts on the Oukitel WP2 requires careful handling and precision. Below are detailed instructions for replacing various components:

Tools Needed:

• Small Phillips screwdriver
• Plastic opening tools
• Tweezers
• Adhesive tape or glue (for reassembly)
• Replacement part (e.g., screen, battery, etc.)

General Instructions:

Before you begin, ensure the device is powered off. Follow these steps meticulously to avoid damaging your phone.

Step-by-Step Replacement Guide:

1. Back Cover Removal:

• Using a Phillips screwdriver, remove all screws from the back of the phone.
• Carefully insert a plastic opening tool in the seam between the back cover and the phone body.
• Gently pry the back cover off, being cautious not to damage the clips.

2. Battery Replacement:

• After removing the back cover, locate the battery connector on the motherboard.
• Use tweezers to carefully disconnect the battery connector.
• Lift the battery out of its compartment.
• To install the new battery, place it in the compartment and reconnect the battery connector.
• Make sure it is seated properly and secured.

3. Screen Replacement:

• After removing the back cover, disconnect the battery to avoid short-circuits.
• Locate the screen connector, typically found near the battery connector.
• Use tweezers to disconnect the screen connector.
• Using a plastic opening tool, pry the damaged screen away from the frame.
• Remove any adhesive residue from the frame using isopropyl alcohol or a gentle cleaner.
• Attach the new screen by connecting the screen connector to the motherboard.
• Secure the new screen into the frame using adhesive tape or glue.

4. Reassembly:

• Once the replacement is complete, reattach the back cover by aligning it with the phone body.
• Press it gently until it clicks into place.
• Reinsert and tighten all screws to secure the back cover.

After reassembly, power on the device to ensure the replacement part functions correctly. If the phone does not turn on, recheck all connections and screws.