Oukitel WP28 spare parts

Oukitel WP28 Technical Characteristics

Oukitel WP28 is a rugged smartphone known for its durability and performance. Below are some key technical characteristics and specifications:

• Display: 5.93 inches, 720 x 1440 pixels resolution
• Processor: MediaTek Helio A22
• RAM: 4GB
• Storage: 32GB, expandable via microSD
• Battery: 5000 mAh
• Operating System: Android 10
• Camera: Dual 13 MP + 2 MP rear, 5 MP front
• Waterproof/Dustproof: IP68/IP69K

Instructions to Replace Oukitel WP28 Parts

Replacing parts on an Oukitel WP28 requires careful attention to detail. This guide provides step-by-step instructions for replacing common parts:

Tools Required

• Small Phillips screwdriver
• Plastic opening tool
• Tweezers
• Suction cup
• Adhesive strips
• Heat gun or hairdryer

Step-by-Step Replacement Guide

1. Preparing the Device

• Power off your Oukitel WP28.
• Remove any SIM card or microSD card.

2. Back Cover Removal

• Use the heat gun or hairdryer to gently warm the edges of the back cover. This loosens the adhesive.
• Use the suction cup to lift the back cover gently.
• Insert the plastic opening tool into the gap and carefully work around the edges to release the clips.

3. Disconnect the Battery

• Locate the battery connector cable and use the plastic opening tool to disconnect it.
• Carefully lift the battery out of the housing using the pull tab.

4. Replacing the Display

• Remove the screws securing the mid-frame using the Phillips screwdriver.
• Lift the mid-frame to access the display connections.
• Disconnect the display cable carefully.
• Use the heat gun or hairdryer to warm the edges of the display.
• Use the plastic opening tool to separate the display from the frame.
• Align the new display and connect the display cable.
• Reassemble the mid-frame by securing the screws.

5. Replacing the Battery

• Align the new battery with the housing.
• Connect the battery connector cable.
• Ensure that the battery is securely in place.

6. Reattaching the Back Cover

• Apply new adhesive strips to the edges of the back cover.
• Align the back cover with the device and press firmly to secure the adhesive.
• Use the heat gun or hairdryer to ensure a good seal.

7. Final Checks

• Power on your Oukitel WP28.
• Verify that the new parts are functioning correctly.

By following these instructions, you can effectively replace components in the Oukitel WP28. Always ensure to work in a clean and static-free environment to avoid damaging any sensitive components.