Oukitel WP7 spare parts

Oukitel WP7 Technical Characteristics

Display

Size: 6.53 inches

Resolution: 2340 x 1080 pixels

Type: IPS LCD

Processor

Chipset: MediaTek Helio P90

CPU: Octa-core (2x 2.2 GHz Cortex-A75 & 6x 2.0 GHz Cortex-A55)

GPU: PowerVR GM9446

Memory

RAM: 8GB

Internal Storage: 128GB

Expandable Storage: microSD, up to 256GB

Camera

Rear Camera: Triple (48 MP main, 8 MP night vision, 2 MP depth sensor)

Front Camera: 16 MP

Battery

Capacity: 8000mAh

Type: Non-removable Li-Po

Charging: Fast charging 18W

Other Features

• OS: Android 10
• Fingerprint Sensor: Rear-mounted
• Water & Dust Resistance: IP68/IP69K rated

Instructions for Replacing Oukitel WP7 Repuestos

Tools Needed

• Small Phillips screwdriver
• Plastic opening tools
• Tweezers
• Spudger
• Suction cup tool

Replacement Steps

1. Power Off the Device

Ensure that the Oukitel WP7 is completely powered off before starting the repair process.

2. Remove the Back Cover

Using a spudger or plastic opening tool, carefully pry around the edges of the back cover to remove it. Be cautious to not damage the clips securing the cover.

3. Disconnect the Battery

Locate the battery connector and use a spudger to gently disconnect it from the motherboard to avoid any electrical issues during the repair.

4. Remove the Screws

Using a Phillips screwdriver, remove all the screws securing the internal components. Keep track of the screw locations to ensure proper reassembly.

5. Disconnect Flex Cables

• Use tweezers or a spudger to carefully disconnect the flex cables attached to the motherboard.
• Ensure to detach the display and digitizer cables if you are replacing the screen.

6. Remove the Old Component

• Carefully lift the defective component (screen, battery, camera, etc.) out of its housing using a spudger or similar tool.
• Be cautious to avoid damaging adjacent parts during removal.

7. Install the New Component

• Place the new component into the correct location in the device.
• Reconnect any flex cables you detached earlier.

8. Reassemble the Device

• Reinstall all the screws you removed, ensuring each is placed in its original location.
• Reconnect the battery connector to the motherboard.

9. Reattach the Back Cover

Snap the back cover back onto the device, ensuring all clips are securely fastened.

10. Power On the Device

Turn on your Oukitel WP7 and test the new component to ensure it is functioning correctly.

Note: If the device does not power on or the new component is not working correctly, recheck all connections and ensure the component is properly installed.