Oukitel Y4800 spare parts

Technical Characteristics of Oukitel Y4800 Repuestos

The Oukitel Y4800 is a mid-range smartphone that features a 6.3-inch FHD+ display, 48MP + 5MP dual rear cameras, a 16MP front camera, and a 4,000 mAh battery. Below are the necessary spare parts (repuestos) that may need replacement:

• Screen Display Assembly: A 6.3-inch IPS LCD with a resolution of 1080 x 2340 pixels.
• Battery: A 4,000 mAh Li-Po battery.
• Rear Camera Module: A dual-camera assembly consisting of a 48MP main sensor and a 5MP depth sensor.
• Front Camera Module: A 16MP selfie camera.
• Charging Port: USB Type-C charging port.
• Fingerprint Scanner: Rear-mounted fingerprint sensor.

Instructions for Replacing Oukitel Y4800 Repuestos

1. Replacing the Screen Display Assembly

• Power off the device completely.
• Remove the SIM card tray using an ejector tool.
• Use a heat gun to gently heat the edges of the screen to soften the adhesive.
• Insert a plastic pry tool between the screen and the frame to carefully lift the display.
• Disconnect the ribbon cables that connect the display to the motherboard.
• Replace with the new screen display assembly by connecting the ribbon cables first.
• Fit the new screen into place, applying gentle pressure to secure it.
• Power on the device to test if the new display is working properly.

2. Replacing the Battery

• Power off the device completely.
• Remove the back cover using a guitar pick or opening tool.
• Disconnect the battery connector from the motherboard.
• Gently pry the battery out of the adhesive securing it to the phone's frame.
• Insert the new battery and connect it to the motherboard.
• Reattach the back cover, ensuring it snaps securely in place.

3. Replacing the Rear Camera Module

• Power off the device completely.
• Remove the back cover using a guitar pick or opening tool.
• Disconnect the camera module connector from the motherboard.
• Carefully remove the old camera module.
• Insert the new camera module and connect it to the motherboard.
• Replace the back cover, ensuring it snaps securely in place.
• Power on the device to test the new camera.

4. Replacing the Front Camera Module

• Power off the device completely.
• Remove the back cover and disconnect the battery.
• Carefully disconnect the front camera ribbon cable from the motherboard.
• Remove the old front camera module.
• Install the new front camera module and reconnect it to the motherboard.
• Reconnect the battery and replace the back cover.
• Power on the device to test the new front camera.

5. Replacing the Charging Port

• Power off the device completely.
• Remove the back cover using a guitar pick or opening tool.
• Disconnect the battery to avoid any short circuits during the procedure.
• Locate and disconnect the ribbon cable linked to the charging port.
• Remove any screws securing the charging port to the frame and gently lift it out.
• Place the new charging port in position and secure it with screws.
• Reconnect the ribbon cable, then reconnect the battery.
• Replace the back cover and power on the device to test the new charging port.

6. Replacing the Fingerprint Scanner

• Power off the device completely.
• Remove the back cover using a guitar pick or opening tool.
• Disconnect the fingerprint scanner cable from the motherboard.
• Gently remove the old fingerprint scanner.
• Install the new fingerprint scanner and reconnect the cable to the motherboard.
• Replace the back cover, ensuring it snaps securely in place.
• Power on the device to test the new fingerprint scanner.