Samsung A05 SM-A055F spare parts

Samsung A05 SM-A055F Technical Characteristics

The Samsung Galaxy A05s SM-A055F is a smart device with diverse features engineered for high performance. Below are some of its technical specifications:

• Screen: 6.5-inch PLS IPS Display, 720 x 1600 pixels, 20:9 ratio (~270 ppi density)
• Processor: Octa-core Mediatek MT6765 Helio P35 (12 nm)
• Storage: 32GB / 64GB Built-in Storage, up to 256GB Memory Card
• RAM: 2GB / 3GB / 4GB RAM
• Camera: 48MP + 2MP + 2MP Triple Rear Cameras, 8MP Front Camera
• Battery: Li-Po 5000 mAh, non-removable
• Software: Android 11, One UI Core 3.1

Instructions to Replace Samsung A05 SM-A055F Parts

Before starting any replacements, remember to turn off the device and remove the SIM and SD cards. Make sure to discharge the remaining power by holding the power button for at least five seconds.

Screen Replacement

• Heat the outer edges of the screen to loosen the adhesive.
• Use a suction cup and a plastic opening tool to create a gap. Once you have enough space, insert a pry tool.
• Slide the pry tool around the edges of the screen to free it from the adhesive. Lift the screen but be cautious of the cable connected underneath.
• Disconnect the screen cable and remove the old screen completely. Replace with the new screen, reconnect the cable, and reapply adhesive to the edge of the new screen.

Battery Replacement

• Remove the back cover of the phone.
• Identify and unscrew the screws securing the battery connector plate, then disconnect the battery cable.
• Insert the plastic tool under the battery and slowly pry it up while making sure not to damage it.
• Now you can replace the old battery with the new one. Connect the battery cable, rearrange the connector plate, and re-screw it.

Camera Replacement

• Remove the back cover and disconnect the battery cable.
• Locate the camera module, unscrew the screws securing it, and disconnect the connector.
• Insert the plastic tool under the camera and carefully pry it up. Replace it with the new camera, reconnect the connector, and screw back the camera module.

Note: This is a general guide. The actual process may vary depending on the specific part being replaced. It's always recommended to seek assistance from a professional if unsure.