Samsung galaxy xcover 4 g390 spare parts

Samsung Galaxy Xcover 4 G390 Technical Specifications

The Samsung Galaxy Xcover 4 G390 is a highly durable smartphone that is designed to support all kinds of outdoor adventures. With its rugged design and powerful performance, it is one of the leading devices in its category.

Key Features and Components

• Screen: 5.0-inch IPS LCD with a resolution of 720x1280 pixels
• Processor: Quad-core 1.4 GHz Cortex-A53
• RAM and Storage: 2GB RAM with 16GB internal storage (expandable up to 256GB with a microSD card)
• Battery: Removable Li-Ion 2800mAh battery
• Camera: 13 MP rear camera with LED flash, 5 MP front camera
• Other Features: MIL-STD 810G certified - salt, dust, humidity, rain, vibration, solar radiation, transport, and thermal shock resistant

Replacing Samsung Galaxy Xcover 4 G390 Parts

Follow these detailed instructions on how to replace components on your Samsung Galaxy Xcover 4 G390. Please make sure to perform these steps carefully to avoid damaging your device.

Tools Needed

• Plastic opening tools
• Phillips #00 Screwdriver
• Spudger

Step by Step Replacement Guide

WARNING: Before starting, ensure your device is powered off and disconnected from any power source.

Step 1: Remove the battery cover and battery. Press the small indentation at the bottom of the device to access the battery compartment.

Step 2: Locate the screws on the back of the device. Using the Phillips #00 Screwdriver, unscrew all 11 screws.

Step 3: Use the plastic opening tool to carefully pry off the back panel. Start from one corner and work your way around.

Step 4: Once the back panel is removed, the internal components will be exposed. Identify the part that needs replacement.

Step 5: Carefully remove the faulty component, using the spudger if necessary to disconnect any attached cables.

Step 6: Insert the new component in the same place, ensuring that all cables are connected accurately.

Step 7: Replace the back panel and fasten all screws.

Step 8: Replace the battery and battery cover.

Step 9: Power on the device to test the new component.

Note: If the device is not operating correctly, power off the device and reinspect your work.