Sony Ericsson W20I spare parts

Technical Characteristics of Sony Ericsson W20I Repuestos

The Sony Ericsson W20I is a robust feature phone from the Walkman series. The ""repuestos"" or spare parts for this device include elements such as the battery, screen, keypad, and housing. Below are the technical specifications for these components:

Battery

• Type: Li-Ion
• Capacity: 930mAh
• Voltage: 3.7V
• Standby Time: Up to 400 hours
• Talk Time: Up to 9 hours

Screen

• Type: TFT, 256K colors
• Resolution: 176 x 220 pixels
• Size: 2.2 inches

Keypad

• Layout: Alphanumeric
• Backlight: Yes

Housing

• Material: Plastic
• Dimensions: 100 x 48 x 15 mm
• Weight: 96 g
• Colors: Black, White

Instructions for Replacing Sony Ericsson W20I Repuestos

Follow the step-by-step instructions below to safely replace the spare parts of your Sony Ericsson W20I:

Replacing the Battery

• Power off the phone and remove the back cover by gently prying it off from the notch at the bottom.
• Take out the old battery by lifting it from the bottom edge.
• Align the new battery and insert it into the compartment, ensuring the contacts match.
• Replace the back cover by aligning it with the slots and pressing down until it clicks into place.

Replacing the Screen

• Power off the phone and remove the battery and back cover.
• Using a small Phillips screwdriver, remove the screws securing the front housing.
• Carefully pry open the front housing using a plastic opening tool.
• Disconnect the ribbon cable attached to the screen.
• Remove the defective screen by lifting it out of the frame.
• Insert the new screen by aligning it in the frame and re-connecting the ribbon cable.
• Reassemble the phone by snapping the front housing back on and securing it with screws.

Replacing the Keypad

• Power off the phone and remove the battery and back cover.
• Remove the screws securing the front housing using a small Phillips screwdriver.
• Open the front housing carefully using a plastic opening tool.
• Remove the old keypad by gently lifting it from its place.
• Align and place the new keypad in the housing.
• Reassemble the front housing and secure it with screws.

Replacing the Housing

• Power off the phone, remove the battery and back cover.
• Remove all screws securing both front and back housings using a small Phillips screwdriver.
• Carefully separate the front and back housings using a plastic opening tool.
• Transfer all internal components to the new housing by carefully removing and placing them in their respective slots.
• Reassemble the new housing by aligning both front and back parts and securing them with screws.