Sony Ericsson X Play R800 spare parts

Technical Characteristics of Sony Ericsson X Play R800 Repuestos

The Sony Ericsson X Play R800 is a smartphone that was popular for its gaming capabilities. The device features several key technical characteristics that any technician or enthusiast should be aware of when considering replacement parts (repuestos).

• Screen Size: 4.0 inches, 480 x 854 pixels
• Processor: 1 GHz Scorpion
• GPU: Adreno 205
• RAM: 512 MB
• Internal Storage: 400 MB, expandable via microSD up to 32GB
• Battery: Removable Li-Po 1500 mAh battery
• Main Camera: 5 MP, autofocus, LED flash
• Operating System: Android 2.3 (Gingerbread), upgradable to 4.0 (Ice Cream Sandwich)

Instructions on How to Replace Sony Ericsson X Play R800 Repuestos

Replacing components in the Sony Ericsson X Play R800 requires a careful approach to avoid damaging other parts of the phone. Below are the detailed steps for the most common replacements.

Replacing the Battery

• Step 1: Power off your phone to avoid any potential electrical damage.
• Step 2: Remove the back cover by gently prying it off from the edges.
• Step 3: Take out the battery by lifting it from the designated notch.
• Step 4: Insert the new battery, ensuring that the contacts align properly with the phone's terminals.
• Step 5: Replace the back cover and power on the device to check if the new battery is functioning correctly.

Replacing the Screen

• Step 1: Power off the phone and remove the battery as instructed above.
• Step 2: Remove any screws holding the midframe together. These are usually located under the back cover and may require a small Phillips screwdriver.
• Step 3: Carefully pry apart the midframe using a plastic opening tool to avoid scratches or cracks.
• Step 4: Detach the screen connector from the motherboard. It may be held in place by a small clip that you need to lift gently.
• Step 5: Remove the old screen from the midframe. You may need to use a heat gun to weaken the adhesive if it is firmly attached.
• Step 6: Place the new screen onto the midframe. Ensure that it fits perfectly and reattach the connector to the motherboard.
• Step 7: Reassemble the midframe and replace all screws.
• Step 8: Reinsert the battery and back cover, then power on the device to verify that the new screen is working.

Replacing the Main Camera

• Step 1: Power off the phone and remove the battery as described previously.
• Step 2: Remove the back cover and midframe screws to access the internal components.
• Step 3: Disconnect the camera module connector from the motherboard. This will be a small, delicate cable, so handle it with care.
• Step 4: Remove the camera module from its housing in the midframe. It may require gentle prying if it's held in with adhesive.
• Step 5: Place the new camera module into the housing, making sure it sits securely.
• Step 6: Reconnect the camera module to the motherboard.
• Step 7: Reassemble the midframe and replace all screws.
• Step 8: Reinsert the battery and back cover. Power on the device to ensure that the new camera is functional.