Sony Ericsson X8 spare parts

Technical Characteristics of Sony Ericsson X8 Parts

The Sony Ericsson Xperia X8 is a smartphone that offers a variety of replaceable parts. Below are some key technical characteristics of the common replacement parts for the Sony Ericsson X8:

Screen

• Type: TFT capacitive touchscreen
• Size: 3.0 inches
• Resolution: 320 x 480 pixels

Battery

• Type: Removable Li-ion
• Capacity: 1200 mAh

Camera

• Type: Single
• Resolution: 3.15 MP

Housing/Body

• Material: Plastic
• Weight: 104 grams
• Dimensions: 99 x 54 x 15 mm

Instructions for Replacing Sony Ericsson X8 Parts

Replacing the Screen:

Follow these steps to replace the screen of your Sony Ericsson X8.

• Power off the Device:
• Remove the Back Cover and Battery:
• Unscrew the Housing:
• Use a suitable screwdriver to remove the screws holding the housing together.
• Separate the Housing:
• Carefully pry apart the front and back housing using a plastic opening tool.
• Disconnect the Screen Connector:
• Locate and disconnect the screen connector from the motherboard.
• Remove the Old Screen:
• Lift the screen gently and remove it from the housing.
• Install the New Screen:
• Place the new screen into the housing and connect the screen connector back to the motherboard.
• Reassemble the Device:
• Screw the housing pieces back together, replace the battery and back cover, then power on the device to test the new screen.

Replacing the Battery:

Here are the steps to replace the battery in your Sony Ericsson X8.

• Power off the Device:
• Remove the Back Cover:
• Take Out the Old Battery:
• Use the indentation at the bottom of the battery to lift and remove it.
• Insert the New Battery:
• Place the new battery into the battery compartment, ensuring correct alignment with the connectors.
• Replace the Back Cover:
• Power on the Device:

Replacing the Camera:

The following steps will guide you through replacing the camera module in your Sony Ericsson X8.

• Power off the Device:
• Remove the Back Cover and Battery:
• Unscrew the Housing:
• Use a screwdriver to remove the screws securing the housing.
• Separate the Housing:
• Pry apart the housing using a plastic opening tool.
• Locate the Camera Module:
• Disconnect and Remove the Camera Module:
• Disconnect the camera module from the motherboard and carefully remove it.
• Install the New Camera Module:
• Connect and secure the new camera module in place.
• Reassemble the Device:
• Screw the housing back together, replace the battery and back cover, and power on the device to test the new camera.