Sony Xperia M2 Aqua D2403 spare parts

Technical Characteristics of Sony Xperia M2 Aqua D2403 Repuestos

Display Assembly

Type: IPS LCD capacitive touchscreen, 16M colors

Size: 4.8 inches, 63.5 cm² (~62.9% screen-to-body ratio)

Resolution: 540 x 960 pixels, 16:9 ratio (~229 ppi density)

Battery

Type: Non-removable Li-Ion 2330 mAh battery

Stand-by: Up to 595 h (2G) / Up to 641 h (3G)

Talk time: Up to 11 h 23 min (2G) / Up to 12 h 1 min (3G)

Music Play: Up to 37 h 33 min

Replacement Parts

• Battery
• Screen Assembly
• Back Cover
• Camera Modules
• Charging Port
• Speaker and Microphone

Instructions for Replacing Sony Xperia M2 Aqua D2403 Repuestos

Tools Required

• Plastic Pry Tools
• Suction Cup
• Small Phillips Screwdriver
• Plastic Spudger
• SIM Card Ejector Tool
• Tweezers
• Adhesive Strips
• Heat Gun or Hair Dryer (for screen removal)

General Instructions to Follow

Before you begin, ensure the phone is powered off to prevent any electrical damage. Work in a clean and organized area to avoid losing any small parts.

Step-by-Step Replacement Guide

1. Remove the Back Cover

• Use a heat gun or hair dryer to soften the adhesive around the edges of the back cover.
• Insert a plastic pry tool into a corner of the back cover to create an opening.
• Gently slide the pry tool around the edges to release the adhesive and remove the back cover.

2. Disconnect the Battery

• Locate the battery connector and use the plastic spudger to disconnect it carefully.
• If replacing the battery, remove any adhesive strips securing the battery and lift the battery out of the phone.

3. Remove the Screen Assembly

• Use the small Phillips screwdriver to remove all screws securing the screen assembly to the frame.
• Apply heat around the edges of the screen to loosen the adhesive.
• Use the suction cup to lift the screen slightly and insert a plastic pry tool to separate the screen from the frame.
• Carefully disconnect the display cable and remove the screen assembly.

4. Replace Necessary Components

• If replacing other components such as the camera modules or charging port, locate the relevant parts and disconnect any connectors holding them in place.
• Use tweezers to handle small components with precision.
• Install the replacement parts, connect the necessary cables, and secure them with screws if needed.

5. Reassemble the Phone

• Reconnect the display cable and place the new screen assembly on the frame. Press gently to secure the adhesive.
• Screw the screen assembly back into place.
• Reconnect the battery and replace the back cover, ensuring it adheres properly.
• Power on the phone to check if all replaced components are functioning correctly.

Following these steps will help you effectively replace the necessary parts on your Sony Xperia M2 Aqua D2403. Be patient and cautious to avoid damaging any components.