Sony XPeria XA3 Ultra I3213 I3223 I4213 I4293 XPeria 10 Plus spare parts

Technical Characteristics of Sony Xperia XA3 Ultra and Xperia 10 Plus Replacement Parts

Compatible Models

• Sony Xperia XA3 Ultra I3213
• Sony Xperia XA3 Ultra I3223
• Sony Xperia XA3 Ultra I4213
• Sony Xperia XA3 Ultra I4293
• Sony Xperia 10 Plus

Key Technical Specifications

• Screen Size: 6.5 inches IPS LCD
• Resolution: 1080 x 2520 pixels
• Processor: Qualcomm SDM636 Snapdragon 636
• RAM: 4GB
• Storage Options: 64GB
• Camera: Dual 12MP + 8MP rear, 8MP front
• Battery: 3000 mAh
• Operating System: Android 9.0 (Pie)

Instructions for Replacing Sony Xperia XA3 Ultra and Xperia 10 Plus Replacement Parts

Required Tools and Materials

• Phillips #00 Screwdriver
• Plastic opening tools
• Suction cup
• Spudger
• Adhesive strips
• Tweezers
• Replacement parts (LCD, battery, back cover, etc.)

Step-by-Step Replacement Guide

1. Power Down the Device

Ensure your phone is completely powered off before beginning the repair process to avoid electrical damage.

2. Removing the SIM and MicroSD Card Tray

Use a SIM ejector tool or a small paperclip to remove the SIM and microSD card tray from the phone.

3. Heating the Back Cover

Use a heat gun or hairdryer to warm the edges of the back cover. This will soften the adhesive and make it easier to remove.

4. Removing the Back Cover

• Insert a suction cup on the back cover to create a small gap.
• Insert a plastic opening tool into the gap and carefully work your way around the edges to loosen the adhesive.
• Gently lift the back cover to remove it completely.

5. Disconnecting the Battery

• Locate the battery connector on the motherboard.
• Use a spudger to gently pry the battery connector up and disconnect it from the motherboard.

6. Removing the Old Parts

• Use a Phillips #00 screwdriver to remove any screws securing the damaged part (e.g., LCD, battery).
• Carefully disconnect any flex cables using tweezers.
• Gently lift out or peel off the old part, being cautious not to damage surrounding components.

7. Installing the New Parts

• Carefully align and place the replacement part in the designated area.
• Reconnect any flex cables that were previously disconnected.
• Secure the replacement part with screws, if necessary.

8. Reconnecting the Battery

• Align the battery connector with its socket on the motherboard.
• Gently press down to reconnect the battery.

9. Reattaching the Back Cover

• Apply new adhesive strips around the edges of the back cover.
• Carefully align the back cover and press it firmly into place.

10. Powering Up the Device

• Reinsert the SIM and microSD card tray.
• Power on the device to ensure that all the replaced components are functioning correctly.